HYPER TOY NDT3001-R Nano Drift Twist RC User Manual
- June 6, 2024
- HYPER TOY
Table of Contents
Nano Drift Twist RC NDT3001-R
USER MANUAL
CONTENTS
BATTERY INSTALLATION
- Push down and slide out the battery cover.
- Put 2 1.5V AA batteries in the battery slots with correct polarity.
- Close the battery cover.
Charging the Vehicle : 30 minutes
- Connect USB to Vehicle charging port.
- Charging power can be from wall plug / computer.
- USB light stop when finish charging.
CAUTION:
Please do not force to change the vehicle height!
It can be controlled with remote controller
FUNCTIONS
SOLUTIONS TO PROBLEMS
This device complies with Industry Canada licence-exempt RSS 210 standard. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Battery Safety Information:
- Ensure that battery polarity is correct.
- Use only batteries of the type recommended (or equivalent).
- Do not mix old and new batteries.
- Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries.
- Rechargeable batteries are to be recharged by Adult only.
- Remove used-up batteries immediately.
- Do not recharge non-rechargeable batteries.
- Do not short-circuit terminals.
- Dispose of batteries safely. Do not dispose of batteries (or products containing non-rechargeable batteries) in fire, as batteries may explode or leak.
FCC Statement
This device complies with the Part 15 of the FCC rules. Operation is subject to the following two conditions: (1)Th is device may not cause harmful interference, and (2) this device must accept any interference received, including interference that maycause undesired operation.
Caution: changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or experienced radio/TV technician for help.
