SimRush Omni Indoor and Outdoor Controller Installation Guide

June 5, 2024
SimRush

SimRush Omni Indoor and Outdoor Controller

SimRush Omni Indoor and Outdoor Controller-FIG-1

SimRush Omni

The Sim Rush Omni is an indoor & outdoor controller/ router for your network. This model is an all-in-one unit combining the Indoor and Outdoor units.
It is pre-configured out of the box and managed through the Sim Rush web portal CPanel. To get online, simply plug-in power to your Sim Rush Go as instructed below.

Quickstart

Make sure you follow the following steps to get online.

  1. Connect the power cable to the unit.
    a. Option 1 – Using the provided 24v 1.2a power pack, plug this into the round power socketSimRush Omni Indoor and Outdoor Controller-
FIG-1Option 2 – Using the provided Power over Ethernet (PoE) injector connect this to the Ethernet socket far left port SimRush Omni Indoor and Outdoor Controller-FIG-2

  2. Connect your PC to the LAN
    a. Ethernet port 7 or 2
    b. Wireless – Default wireless is “SimRush-xxxxxx” and the Serial number as the password, e.g AABBCC112233
    – Serial number is located on the box or back of the controller, and is all characters before the “/123”

  3. Ensure the SIM (if not pre-installed) is inserted correctly
    An a. The SimRush Omni uses a “Micro” SIM size.
    b. It is inserted to the Right side of the unit, Metal SIM side u P, and with the cutout corner toward the Right side of the unitSimRush Omni Indoor and
Outdoor Controller-FIG-3

  4. To make changes to the LAN address or Wireless settings, please visit SPanel: https://portal.simrush.com/ ~Xf~

!Use the following steps to access the Sim Rush Go unit to make changes to APN settings or check SIM/Carrier status information:

  1. Ensure you are connected to the Sim Rush Controller via Ethernet or WiFi.

  2. Using a browser, browse to http:l/192.168.10.1/
    a. Login details are, Username: installer, Password: blank (There is no password set)

  3. Once you have logged in, the main status page will show you the current carrier/ APN information along with signal information
    To Change the APN:
    i. At the top left corner, click “Interfaces”, the page will refresh
    ii. You will need to then click on “lte1” under the name column. the page will refresh again
    iii. Under the “General” section, click on the dropdown on the line for” APN Profile” – by default this will
    be set to EE, click the down arrow “V” which will list other carriers which are pre-generated in the list
    iv. Select the desired carrier, then click apply/OK at the top of the page

  4. Further information about the Outdoor unit settings can be found on the Sim Rush FAQ’s section of the Sim Rush website: https://www.simrush.com/about-simrush/faqs/

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals