SimRush Pro WiFi Indoor Controller Installation Guide
- June 5, 2024
- SimRush
Table of Contents
SimRush Pro WiFi Indoor Controller
SimRush Pro & SimRush Pro WiFi
The SimRush Pro & SimRush Pro WiFi is an indoor controller/router for your network. This model can support up to 2 Outdoor units (Note that the Pro model does not have built-in WiFi, additional hardware required). It is pre- configured out of the box and managed through the SimRush web portal CPanel. To get online, simply plug in your SimRush Outdoor unit (ODU) as instructed below.
Quickstart
Make sure you follow the following steps to get online.
-
Connect the ethernet cable to Ethernet Port 10 for ODU1, and Ethernet Port 9 for ODU2 (far right ports – Highlighted in GREEN) – Please note that Port 9 requires the supplied PoE injector.
-
Connect the Controller to the power adaptor supplied (24v 2.5a DC)
-
Connect your PC to the LAN (Highlighted in ORANGE )
a. Ethernet port 2-8 and SFP
b. The Pro model does not have a Wireless card, additional SimRush wireless hardware will automatically connect to the controller and broadcast – Default wireless is “SimRush-xxxxxx” and the Serial number as the password, e.g AABBCC112233 – Serial number is located on the box or back of the controller, all characters before the “/123” -
To make changes to the LAN address or Wireless settings, please visit SPanel: https://portal.simrush.com/
-
(OPTIONAL) Connect your alternative broadband to utilise the built-in Load-Balancing feature, connect Ethernet Port1 ( Highlighted in RED ) to your alternative broadband network. Please ensure your alternative broadband router is providing the following network via DHCP: Gateway: 192.168.1.1, Subnet: 255.255.255.0
SimRush Pro & Pro WiFi
- SFP+ – LAN Port
- Ether1 – AUX1 Port
- Ether2 – LAN Port
- Ether3 – LAN Port
- Ether4 – LAN Port
- Ether5 – LAN Port
- Ether6 – LAN Port
- Ether7 – LAN Port
- Ether8 – LAN Port
- Ether9 – ODU2 Port
- Ether10 – ODU1 Port