BARBELL STANDARD STO-1011 Weight Plate Tree Bar Storage Instruction Manual
- June 17, 2024
- BARBELL STANDARD
Table of Contents
BARBELL STANDARD STO-1011 Weight Plate Tree Bar Storage
Package Contents
QTY Description
- 2x 24” legs
- 1x 20” base
- 1x 49.5” Upright
- 2x A-brackets
- 2x Rectangle plates
QTY Description
- 8x Bolts (15mm)
- 8x Washers
- 8x Hex nuts
- 4x Rubber feet
- 6x Caps
- 2x Wrenches (15mm)
IMPORTANT NOTE
Load weights low and on both sides of the tree if you intend to store more
than 250 pounds of plates for extended periods of time.
Step 1
Items needed for Step 1
- 2x A 2x E 4x I
- 1x B 4x F, G, H 2x K
Place washers G on bolts F. Put two bolts through each plate E. Bolts of one E pass through one of A and then through one side of B. Attach nuts H to bolts. Repeat for other side. Attach all four rubber feet I to ends of A. Ensure the legs are level, loosen H to adjust as needed
Step 2
Items needed for Step 2
2x D 2x F, G, H 2x KPlace washers G on bolts F. Place the two bolts through
one of the plates D. Pass the two bolts through B (assembled Step 1), then
through the other D. Tighten nuts H loosely (you’ll tighten them in the next
step).
Step 3
Items needed for Step 3
- 1x C 6x J
- 2x F, G, H 2x K
Place washers G on bolts F. Rest C to sit level on B, directly in between the two loosely fastened D. Place the bolts through D, then C, and then out through the other D. Fasten nuts H, tightly, and then tighten the two loose nuts from Step 2. Insert all caps J into C.
Step 4
Load up your weight tree and share
- Load up your plates and bar/s
- Snap some pictures
- Show us your setup!
Storage Overview
- 6” Top Posts
- 12 2.5 lb plates (each)
- 9 5 lb plates (each)
- 6 10 lb plates (each)
- 8“ Middle Posts
- 12 10 lb plates (each)
- 6 25 lb plates (each)
- 5 35 lb plates (each)
- 10” Bottom Posts
- 7 25 lb plates (each)
- 7 35 lb plates (each)
- 7 45 lb plates (each)
- Olympic Bar Holders
- 2 2” Olympic Bars
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>