VICTRIX 052-003 Gambit Wireless Surround Sound Gaming Headset User Guide
- June 5, 2024
- VICTRIX
Table of Contents
VICTRIX 052-003 Gambit Wireless Surround Sound Gaming Headset
WHAT’S IN THE BOX
- Gambit Wireless Headset **
**
- Wireless USB Dongle **
**
-
USB Cable
-
3.5mm Cable with In-Line Controls
-
Setup/Pairing
-
Plug dongle into the USB port and power on headset. Both should pair automatically. If headset and dongle are not paired:
-
Press and hold button on USB Dongle until LED blinks rapidly.
-
Press and hold power button on headset until it pairs with USB Dongle (Solid LED).
-
Flip-to-Mute (in WIRELESS MODE only) **
**
1. Mic Boom up to mute.
2. Mic Boom down to unmute. Mic Monitoring Allows you to hear your voice through the headset when you speak.
3. The MODE button controls your headset’s mic monitoring levels in WIRELESS MODE only (1 beep = Off; 2 beeps = Normal; 3 beeps = High).-
Audio Controls
Adjust the headset to your preferred audio levels using the dial on the right ear cup for volume (in WIRELESS MODE only). The headset also comes with a detachable 3.5mm in-line cable with a volume dial and mute switch for passive mode. -
Charging
To charge, plug USB cable into headset. Up to 16 Hours of Battery Life. -
Pulsing LED = Charging.
-
Solid LED = Charged.
-
Low Battery Tone = Descending Tones every minute.
-
Microphone Settings
To adjust microphone level: Go to the PlayStation® 5 menu > Settings > Sound > Microphone > Adjust Microphone Level.
- 3D Audio Settings
To enable 3D Audio: Go to the PlayStation® 5 menu > Settings > Sound > Audio Output > Enable 3D Audio and turn it on.
- Volume Settings
To adjust your volume: Go to the PlayStation® 5 menu > Settings > Sound > Volume
2021 Victrix. Victrix and its respective logos are trademarks and/or
registered trademarks of Victrix. All rights reserved. “ ”, “PlayStation”,
“PS5”, “PS4”, “Dual Sense”, “DUALSHOCK”, and “PlayStation Shapes Logo” are
registered trademarks or trademarks of Sony Interactive
Entertainment Inc. All rights reserved. All other trademarks are the property
of their respective owners. Manufactured and distributed under
license from Sony Interactive Entertainment LLC. Hereby, Victrix, declares
that this device is in compliance with the essential requirements and other
relevant provisions of Directive 2014/53/EU. The declaration of conformity may
be consulted at www.pdp.com/en/sitemap
FCC AND IC STATEMENT FOR WIRELESS PRODUCTS
CAUTION:
Changes or mode cations not expressly approved by the party responsible for
compliance could void your authority to operate the equipment. The equipment
complies with FCC RF exposure limites set forth for an uncontrolled
environment. The equipment must not be co-located or operating in conjunction
with any other antenna or transmitter. This equipment has been tested and
found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by urning the equipment and on, the user is encouraged to
Try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC ID: X5B-052003R/T
This device complies with FCC radiation exposure limits set forth for an
uncontrolled environment and it also complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
IC: 8814A-052003R/T
Under Industry Canada regulations, this radio transmitter may only operate
using an antenna of a type and maximum (or lesser) gain approved for the
transmitter by Industry Canada,. To reduce potential radio interference to
other users, the antenna type and its gain should be so chosen that the
equivalent isotopically radiated power (e.i.r.p.) is not more than that
necessary for successful communication.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>