EDIC CR2 Touch-Free Restroom Cleaning Equipment User Guide
- June 5, 2024
- EDIC
Table of Contents
Quality Above All
CR2
Pump Prime Quick Start Guide
CR2 Touch-Free Restroom Cleaning Equipment
Follow these 4 easy steps to ensure proper pump-priming on the CR2
STEP 1:
Make sure you have water in the solution tank in the CR2. Set the mode
selector switch to RINSE and the pressure release valve to PRIME as shown in
the photo.
Step 2:
Using the control switches found on the handle of the CR2, turn on the pump
and the vacuum.
Step 3:
Place your hand over the vacuum connection on the CR2 for about 20 to 30
seconds to help pull the air out of the solution lines. Release the hand from
the vacuum connection and move to step 4.
Step 4:
Turn off the pump and the vacuum from the switches on the handle of the CR2.
VERY IMPORTANT – move the prime release valve back to the up position or
operation mode before you start cleaning. Failure to do this will result in no
pressure at the end of the spray gun.
Questions? Contact Us: 877.977.3339
Documents / Resources
| EDIC
CR2 Touch-Free Restroom Cleaning
Equipment
[pdf] User Guide
CR2, Touch-Free Restroom Cleaning Equipment, CR2 Touch-Free Restroom Cleaning
Equipment
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>