Knightsbridge EX004H 100mm LED Backlit Extractor Fan Instruction Manual

Knightsbridge EX004H 100mm LED Backlit Extractor Fan

GENERAL INSTRUCTIONS

These instructions should be read carefully and retained after installation by the end user for future reference and maintenance.

These instructions should be used to aid installation of the following products:
EXO03T/EXxO04T/ EXOO5T/ EXO06T

SAFETY

• This product must be installed in accordance with the latest edition of the IEE Wiring Regulations (B57671) and current Building Regulations. If in any doubt, consult a qualified electrician
• Please isolate mains prior to installation or maintenance
• Check the total load on the circuit (including when this product is fitted) does not exceed the rating of the Circuit cable, fuse or circuit breaker
• Please note the IP (Ingress Protection) rating of this product when deciding the location for installation
• This product is Class l double insulated
• This product is IPX4 rated

INSTALLATION

Note: If this product is being used in conjunction with an external PIR or sensor, please contirm with the manutacturer of the sensors that they are compatible.

• Provide power to the required point of nstallation

• Lut a suitable 1uumm diameter hole in the mounting surtace ensuring not to intringe with any joists, gas/ water PIpes or electrical cables. Install sutable ducting and a suitable external grille or shutter. Ihe maximum length of ducting to be used is 2m

• Remove the front fascia (see ig. 1)

• Remove the taceplate by remOving the screw at the bottom ot the product and lifting oft

• Mark the location of the fixing holes and drill ensuring not to intringe with any gas / water pipes or electrical
  cables

• Remove the cable knock- out on the baseplate and guide the mains cable through

• Fix the base to the mountng Surtace using the tixings provided

• Remove the terminal cover by removing the twO Screws (see Fig. 2)

• Lareruly Dring tne wires into tne terminal enclosure and ensuring coTect polarity Is ODservea, wire as
  shown in Fig..

• Adust the overrun timer with the aid of a small screwdriver, lurm anti-clockWise to reduce [to a minimum
  of 2 minutes) and clockwise to increase (to a maximum of 30 minutes)

• Reassemble the terminal cover, faceplate, and front fascia

• Switch on and check tor correct operation

WARNING: This product must be disconnected from the circuit if subjected to any high voltage or insulation resistance testing. Irreparable damage will occur if this instruction is not followed.

GENERAL

The LED lamps fitted in this product are non-replaceable. The product should be recycled in the correct
manner when it reaches the end of its life. Check local authorities for where facilities exist.
Clean with a soft dry cloth only, do not use aggressive cleaning products or solvents which may damage the
product.

This product is non-dimmable.

WARRANTY

This product has a warranty of 3 years from date of purchase. Failure to install this product in accordance with the current edition of the IEE Wiring Regulations (BS7671), improper use, or removal of the batch code will invalidate the warranty. If this product should fail within its warranty period, it should be returned to the place of purchase for a free of charge replacement. ML Accessories does not accept responsibility for any installation costs associated with the replacement product. Your statutory rights are not affected ML Accessories reserve the right to alter product specification without prior notice.

ML Accessories Limited LU5 4LT
www.mlaccessories.co.uk

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>