baudcom BD-ONU-111 access network total solution suppliers User Manual
- June 5, 2024
- Baudcom
Table of Contents
baudcom BD-ONU-111 access network total solution suppliers
Connect Your ONU
The installation guide that came in the box has a cabling diagram. This section walks you through how to connect your ONU with detailed illustrations.
Interface and LED definitions
To connect your ONU:
Please connect the LAN port of the ONU to the network adapter of your Computer
with one cable. Please connect your optical fiber to the PON port of your ONU.
Please use the delivery-attached power adapter to the ONU, and plug the power
adapter into an outlet. Wait for the Power LED on the front panel to light. If
no LEDs are lit, press the Power On/Off button on the rear panel of the ONU.
Login ONU WEB Management
Prepare for login the ONU web management Before you log in the ONU, you should
confirm the connection between the ONU and your PC is normal.
Step 1 Configuring the IP address of your PC to 192.168.1.X (2-254) subnet
mask is 255.255.255.0,
Step 2 Ping IP address of the ONU (Default address is 192.168.1.1). If the PC
can get right reply from the Ping command, it is mean the connection between
the PC and ONU is normal
Note: Please don’t power off the ONU in the process of managing the ONU by the
WEB
Login ONU
Step 1 Open the explore browser and input the IP address
“http://192.168.1.1”(ONU default IP)。
Step 2 You need the user name and password for login. The default user name
and password are on the label of the ONU bottom. The default administrator
user name and password is “admin” and “admin”
After you log in to the ONU as the administrator, you can check, configure and
change the configuration of the ONU. Some of configuring and changing will
take effect only after restarting the ONU.
Login success, a “Device Information” window will show as below. There are
seven-item of the status function. It is model, serial number, hardware
version, software version, boot loader version, PON serial number, and
password.
Network Management
Create WAN: Click “Network—–>WAN—–>WAN Connection”, You can check or configure the Bridge and Route mode, click the “Create” button.
LOID Configuration:
Click “Network—–>PON—–>LOID”, You can check or configure the ONU LOID and
Password, click the “Submit” button after configuring.
SN Configuration:
Click “Network—–>PON—–>SN”, You can check or configure the ONU SN and
Password, click the “Submit” button after configuring.
Note: Configure password take effect after rebooting the device.
User Management
Click “Administration—–> User Management”, You can configure the ONU Username and Password, click the “Submit” button after configuring.
System Management
Click “Administration—–>System Management”, You can configure the ONU reboot
and restore the factory default.
Click“Administration—–>System Management—–>User configuration”, You can backup or restore the ONU configuration.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>