BAZZ STKLGU3W4 straight split jeans Instruction Manual
- June 5, 2024
- BAZZ
Table of Contents
BAZZ STKLGU3W4 straight split jeans
INSTRUCTIONS
WARNING: Do not bury the cable before testing the installation.
1. Install the transformer.
2. Unroll the wire on the desired path.
3. Split one end of the cable approximately 3 (8cm) being careful to cut down
the middle and not expose the copper wire. Strip (1cm) of the insulation on
this end and connect it fo the transformer. Make sure the insulation clears
the pressure plates
4. Place the fixtures evenly along the cable. The first fixture must be at a
minimum of 10 (3m) from the transformer. there’s extra cable, coil or cut it
after the last focture Do not install a fixtures less than 10 (3m) from a pool
or spa.
5. Turn on the transformer
6. Connect the fixture to the low voltage cable.
7. Ater you’ve tested the proper fonctioning of your system, the cable may be
buried up to 3 (8cm) deep.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>