BAZZ JLDSK4W44 Recessed Fixture Instruction Manual
- June 9, 2024
- BAZZ
Table of Contents
BAZZ JLDSK4W44 Recessed Fixture
PARTS LIST
- JUNCTION BOX
- LIGHT PANEL
- CLIPS
- CONNECTOR
- KNOCKOUT HOLE
LIGHT SOURCE (INCLUDED)
SOURCE LUMINEUSE (INCLUSE)
INTEGRATED LED
10W
WARNING
Luminaires must be installed by a certified electrician. Check with local and
national codes for proper installation.
To prevent electrical shock, disconnect electrical supply before installation
or servicing.
Do not modified this fixture. Any modifications may render the product unsafe
and void the warranty. This product is suitable for damp locations.
Installation
Turn Off power from the electrical panel prior to installation.
Determine the location where you want to install the fixture and cut a 4 4
(108 mm) hole in the ceiling according to the template on the box (fig. 1).
Open the junction bOX COver and remove the appropriate knockout(s) on the side
panel (fig. 2).
Insert the electrical supply cable through the knockout and secure with a wire
connector.
Using quick-connect, connect the ground wire to the ground wire terminal;
black wire to black wire terminal; white wire to white wire terminal (fig. 2
).
Place all wiring and connections back into the junction box and close the
cover.
Connect the junction box to the light panel with the quick-connect system.
Insert the junction box through the mounting hole (fig. 3).
Push clips on the fixture upwards and insert fixture base into the mounting
hole. Release the clips and fixture will be pulled flush to the ceiling (fig.
4).
NOTE: The back of the unit and the junction box must not be exposed to damp
locations (fig. 5).
Use a silicone sealant for damp locations.
You must keep a minimum space of 2″ (12.7 mm) between the junction box and the
disk (fig. 6).
WARRANTY
BAZZ’s warranty applies to manufacturing defects affecting its products which
existed at the time of the purchase of the product, that are non-apparent, and
are unknown to the buyer, for a period of 3 years. This warranty applies to
the product only and does not cover the instalation of the product. he
warranty does not apply to material, economic, and/or physical damages or
losses caused by the product. This warranty will not apply to any damages
and/or losses caused by an incorrect use, installation or maintenance of the
product. The manufacturer is therefore not liable for damages to the product
or material, economic and/or physical damages or losses caused by an incorrect
use, installation or maintenance of the product. If the buyer Considers that
the product is affected by a defect, the buyer should return the product to
the point of purchase or send an email to
service@bazz.ca. Should the buyer decide to send an
email to service@bazz.ca, a description of the
alleged problenm should be included in the email and a proof of purchase as
well as the picture clearly illustrating the alleged defect should be attached
to the email. The buyer should also return the product to BAZZ at his/her own
expense.
After product inspection, if the warranty applies, BAZZ will repair or replace
the product free of charge.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>