AVANTCO 193BC36HC 36 Inch Curved Glass Refrigerated and Dry Bakery Case User Manual

: June 5, 2024
: AVANTCO

Table of Contents

Structure and Components
Installation
Operation/Maintenance
Warranty Information
Documents / Resources

User Manual

Refrigerated and Dry Bakery Case

Refrigerated Bakery Models:
193BC36HC, 193BC48HC, 193BC60HC, 193BC72HC, 193BC72HC, 93BCT36B, 193BCT36W,193BCT48B, 193BCT48W, 193BCT60B, 193BCT60W, 193BCT72B, 193BCT72W

Dry Bakery Models:
193BCD36, 193BCD48, 193BCD60, 193BCD72, 193BCD72, 193BCTD36B, 193BCTD36W,193BCTD48B, 193BCTD48W, 193BCTD60B, 193BCTD60W, 193BCTD72B, 193BCTD72W

Please read the manual thoroughly prior to equipment set-up, operation and maintenance.

Warning
DANGER RISK OF FIRE OR EXPLOSION. FLAMMABLE REFRIGERANT USED. TO BE REPAIRED ONLY BY TRAINED SERVICE PERSONNEL. DO NOT PUNCTURE REFRIGERANT TUBING.
CAUTION – RISK OF FIRE OR EXPLOSION. FLAMMABLE REFRIGERANT USED. CONSULT REPAIR MANUAL/OWNER’S GUIDE BEFORE ATTEMPTING TO SERVICE THIS PRODUCT. ALL SAFETY PRECAUTIONS MUST BE FOLLOWED.
CAUTION – RISK OF FIRE OR EXPLOSION DUE TO PUNCTURE OF REFRIGERANT TUBING; FOLLOW HANDLING INSTRUCTIONS CAREFULLY. FLAMMABLE REFRIGERANT USED.
CAUTION – RISK OF FIRE OR EXPLOSION DUE TO FLAMMABLE REFRIGERANT USED. FOLLOW HANDLING INSTRUCTIONS CAREFULLY IN COMPLIANCE WITH LOCAL GOVERNMENT REGULATIONS.

Structure and Components

Installation

Please read this manual thoroughly prior to equipment set-up, operation and maintenance.

Important!!! Please Read Before Installation

If the unit has recently been transported on its side, please let the unit stand upright for a minimum of 24 hours before plugging it in.
Make sure all accessories are installed (shelves, shelf clips, etc…) before plugging in the unit.
Make sure the unit has reached the desired temperature before loading the unit with products.
Do not attempt to remove or repair any component of the unit. Consult an authorized service technician for servicing / repair.
Do not hang on doors or stand inside the unit.
Please read through this manual in its entirety.

Cabinet Location Guidelines

Install the unit on a strong and leveled surface.
- If the surface is uneven, the unit may be noisy.
- The unit may malfunction if the surface is uneven.
Install the unit in an indoor, well-ventilated area.
- For best performance, maintain 6” of clearance on the sides and the back of the unit at all times.
- Outdoor use may cause decreased efficiency and damage to the unit.
- Avoid direct sunlight.
Avoid installation in a high humidity and/or dusty area.
- High humidity can cause the unit to rust and may decrease efficiency.
- Dust collected on the condenser coil may cause unit to malfunction.
- Malfunction due to high ambient temperatures, humidity, or improperly maintained condenser coil will void the warranty.
Select a location away from heat and moisture-generating equipment.
- High ambient temperatures may cause the compressor to malfunction.
- Malfunction due to high ambient temperatures and humidity will void the warranty.

Use and Caution

Your new refrigerator is already factory-set to run at optimum temperatures for food safety and should require no adjustments.

Digital Temperature Controller (Refrigerated models only)

Front Panel Operation

Set temperature:
Press button, the set temperature is displayed.
Press or to modify the displayed value.
Press button to exit the adjustment and display the unit’s current temperature.
If no more buttons are pressed within 10 seconds, the unit’s current temperature will be displayed.
Lights: Press button to turn lights ‘on’ or ‘off’. Manual start/stop defrost: Press button and hold for 6 seconds to defrost or stop defrost.
Refrigerant LED: When the compressor is running, the LED is on; when the refrigerator temperature is constant, the LED is off; During the delay start, the LED flashes.
Defrost LED: during the defrost cycle, the LED is on; when it stops defrosting, the LED is off. During the delayed display of defrost, the LED flashes.

Electrical

Please ensure that the required voltage is being supplied at all times.
The unit should be plugged into a grounded and properly-sized electrical outlet with appropriate over-current protection. Please refer to the electrical requirements on the unit’s nameplate.
The unit should have its own dedicated outlet.
Do not use extension cords.
Ensure the unit is not resting on or against the electrical cord.
If the unit is not in use for a long period of time, please unplug the unit from the outlet.
To avoid shock and fire hazards, do not plug in or unplug the unit with wet hands.
After unplugging the unit, wait at least 10 minutes before plugging it back in. Failure to do so could cause damage to the compressor.

Defrost System

Refrigeration units contain an automatic defrost system. Refrigeration coils are kept below the freezing point (32 degrees fahrenheit). During compressor downtime, the evaporator fan continues to circulate air through the evaporator coil. This air circulation raises the coil temperature above the freezing point, melting any accumulated frost. Run-off water is drained into the evaporator pan and evaporated.

Operation/Maintenance

NOTE: We strongly recommend that any servicing be performed by an authorized service technician.

Loading Product

Do not block the air vents.
Ensure all shelves are sitting level and properly secured before loading products.
Do not store flammable and explosive gas or liquids inside the unit.

Cleaning the Condenser Coil

For efficient operation, keep the condenser surface free of dust, dirt, and lint.
We recommend cleaning the condenser coil at least once per month.
Clean the condenser with a commercial condenser coil cleaner, available from any kitchen equipment retailer.

Cleaning the Fan Blades and Motor

If necessary, clean the fan blades and motor with a soft cloth.
If it is necessary to wash the fan blades, cover the fan motor to prevent moisture damage.

Cleaning the Interior of Unit

When cleaning the cabinet interior, use a solvent of warm water and mild soap.
Do not use steel wool, caustic soap, abrasive cleaners, or bleach that may damage the interior finish.
Periodically remove the shelves and shelf brackets from the unit, and clean them with a mild soap and warm water.

Warranty Information

Limited Service Warranty – Valid only in the United States

1 Year Parts and Labor Warranty
Unless otherwise stated, Avantco Refrigeration warrants to the original purchaser of new Avantco Refrigeration units (and all parts thereof), that such equipment will be free from defects in material and workmanship for a period of 1 year from the date of delivery.

5 Year Compressor Warranty
In addition to the 1 year parts and labor warranty above, Avantco Refrigeration warrants the compressor on select units to be free of defects in material and workmanship for a period of 5 years from the date of delivery. This additional warranty applies to the following product series:
UBB, UDD, PICL, SCL, MC, JBC, GDC, CFD, CBE, SSPT, APT, APPT, SS, HBB, GF, A-Series, VAC, CP, BC, MC, SSUC, SSWT, GF, DLC
On products without the 5 year compressor warranty, the compressor is covered for 1 year under the standard parts and labor warranty.

What This Warranty Does Not Cover:
Avantco Refrigeration will not warrant coverage for component failure or other damages that arise under the following conditions:

Failure to install and/or use the unit within proper operating conditions specified by Avantco Refrigeration.
Failure to properly maintain the unit. This includes, but is not limited to, basic preventative maintenance like cleaning the condenser coil.
Installation in non-commercial or residential applications.
Products sold or used outside of the United States.
Any damage that occurs as a result of negligence or improper handling.
Overloading or improper loading of the unit in a manner that prevents proper airflow.

Additionally, no claims can be made against this warranty for spoilage of products, loss of sales or profits, or any other consequential damages.
Normal wear type parts, such as light bulbs and gaskets, are not included in warranty coverage.

For Warranty Inquiries or Service:
This warranty is only valid on equipment purchased from an authorized dealer. A list of authorized dealers for your state can be found by going to avantcorefrigeration.com.

Locate the model number (located on the front of the unit, or inside the door jamb).
Locate the bold number on the service plate (located on the front of the unit).

Next, call 1-800-678-5517. You must have the model number and service plate number when contacting service technicians.
Failure to contact Avantco Refrigeration prior to obtaining equipment service may void your warranty.

Documents / Resources

| AVANTCO 193BC36HC 36 Inch Curved Glass Refrigerated and Dry Bakery Case [pdf] User Manual
193BC36HC, 193BC48HC, 193BC60HC, 193BC72HC, 193BC72HC, 93BCT36B, 193BCT36W, 193BCT48B, 193BCT48W, 193BCT60B, 193BCT60W, 193BCT72B, 193BCT72W, 193BCD36, 193BCD48, 193BCD60, 193BCD72, 193BCD72, 193BCTD36B, 193BCTD36W, 193BCTD48B, 193BCTD48W, 193BCTD60B, 193BCTD60W, 193BCTD72B, 193BCTD72W, 193BC36HC 36 Inch Curved Glass Refrigerated and Dry Bakery Case, 36 Inch Curved Glass Refrigerated and Dry Bakery Case
---|---