deco chef DCICM Counter Top 40 LB Ice Maker Instruction Manual

Counter Top
40 LB Ice Maker
Instruction Manual

For the DCICM Models
Please read this instruction manual before using your portable ice maker.
We recommend that you keep this in a safe place for future reference.
View this product on decogear.com

IMPORTANT SAFETY INSTRUCTIONS

Your safety and the safety of others are very important.
Provided within are a number of important safety messages for your appliance.
Always read and obey all safety messages.
This is the safety alert symbol:
All safety messages will follow the safety alert symbol along with the word “DANGER” or “WARNING”.
DANGER
WARNING
These words mean: You can be killed or seriously injured if you don’t fully follow these instructions. All safety messages will tell you what the potential hazard is, how to reduce the chance of injury, and what can happen if instructions are not followed.3

**PREPARING YOUR ICE MAKER FOR USE

**

IMPORTANT SAFETY TIPS
When using electrical appliances, basic safety precautions should be followed to reduce the risk of fire, electric shock, and injury to persons or property. Read all instructions before using any appliance.

• Do not operate this, or any other appliance with a damaged cord.
  Connect to properly polarized outlets only. No other appliance should be plugged into the same outlet. Be sure that the plug is fully inserted into the receptacle.

• Do not run the power cord over carpeting or other heat insulators. Do not cover the cord.
  Keep cord away from traffic areas, and do not submerge in water.

• We do not recommend the use of an extension cord, as it may overheat and become a fire risk. If you must use an extension cord, use No.14 AWG minimum size, rated no less than 1875 watts.

• Unplug the ice maker before cleaning, making any repairs, or servicing.

• Exercise caution and use reasonable supervision when the appliance is used near children.

• Do not use your ice maker outdoors. Place the ice-maker away from direct sunlight and make sure that there is at least 6 inches of space between the back of your unit and wall. Keep a minimum distance of 6 inches on each side of your unit free.

• Do not use other liquids to make the ice cubes other than water.

• Do not clean your ice maker with flammable fluids. The fumes can create a fire hazard or explosion.

• Do not tip over.

• If the ice maker is brought in from outside in the wintertime, give it a few hours to warm up to room temperature before plugging it in.
  WARNING: This appliance must be properly grounded.

• DANGER – Risk Of Fire or Explosion. Flammable Refrigerant Used. Do Not Use Mechanical
  Devices To Defrost Ice Maker. Do Not Puncture Refrigerant Tubing.

•   DANGER – Risk Of Fire Or Explosion. Flammable Refrigerant Used. To Be Repaired Only By Trained Service Personnel. Do Not Puncture Refrigerant Tubing.

• CAUTION – Risk Of Fire Or Explosion. Flammable Refrigerant Used. Consult the Repair Manual/Owner’s Guide Before Attempting To Install or Service This Product. All Safety Precautions Must be Followed.

• CAUTION – Risk Of Fire Or Explosion. Dispose Of Properly In Accordance With Federal Or Local Regulations. Flammable Refrigerant Used.

• CAUTION – Risk Of Fire Or Explosion Due To Puncture Of Refrigerant Tubing; Follow Handling Instructions Carefully. Flammable Refrigerant Used.

• The ice maker should be installed in accordance with the safety standard for Refrigeration Systems, ASHRAE15. The ice maker shall not be installed in corridors or hallways of public buildings.

• If the unit has a problem or needs to be maintained, replacement with like components and servicing shall be done by factory-authorized service personnel, so as to minimize the risk of possible ignition due to incorrect parts or improper service.

IMPORTANT:
The wires in this unit are colored in accordance with the following code:
Green or Green with a yellow stripe: Grounding
White: Neutral
Black: Live
To avoid a hazard due to the instability of the appliance, it must be placed at an even or flat surface.

GETTING TO KNOW YOUR UNIT

1. Water reservoir cover

2. Unit top cover

3. Water separator pipe

4. Evaporator

5. Ice basket

6. Ice scoop

7. Transparent window

8. Control Panel:
   A. Timer button
   B. Power button
   C. LCD Display area
   1. Ambient temp and ice-making countdown symbol: when the display shows , ice is
   being made.
   <℉> displays the temperature.
   2． Ice-making and Ice harvesting symbols: when the ice cube symbol is on, the unit
   is making ice cubes. When the symbol flashes, the unit is harvesting ice.
   3． ON/OFF symbol.
   4． Error code E1-Ambient temp sensor breakdown. E2-refrigerating tube sensor breakdown
   5． Lack of water warning symbol.
   6． Ice full symbol.
   7． Time setting display area. notes timer unit ON/OFF. When is active, a preset ice-making time has been set.
   D. Ice making and timer decrease.
   E. ice making and timer increase.

9. Hot Air Outlet

10. Water draining port: To drain water from the unit.

OPERATING PROCEDURES & MAINTENANCE

UNPACKING YOUR ICE MAKER

1. Remove the exterior and interior packaging. Check that ice basket and ice scoop is included. If any parts are missing, please contact our customer service.
2. Clean the interior with lukewarm water and a soft cloth. Take out the ice basket and clean it
3. Find a location for your ice maker that is protected from direct sunlight and other sources of heat (i.e.: stove, furnace, radiator). Place the ice maker on a level surface. Make sure that there is at least 6 inches of space between the back and sides of your ice maker and the wall.
4. Allow one hour for the refrigerant fluid to settle before plugging ice maker in.
5. The appliance must be positioned so that the plug is accessible.
   WARNING: fill with potable water only.
   CONNECTING YOUR ICE MAKER

DANGER

• Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is damaged please call our customer service.

  1. This unit should be properly grounded for your safety. The power cord of this appliance is equipped with a three-prong plug which mates with standard three prong wall outlets to minimize the possibility of electric shock.
  2. Plug your appliance into an exclusive, properly installed, grounded wall outlet. Do not under any circumstances, cut or remove the third (ground) prong from the power cord. Any questions concerning power and/or grounding should be directed toward a certified electrician.
  3. This appliance requires a standard 110-120volt, 60Hz electrical outlet with three-prong ground.

CLEANING AND MAINTAINING YOUR ICE MAKER
Before using your ice maker, it is strongly recommended to clean it thoroughly.

1. Take out the ice basket.
2. Clean the interior with diluted detergent, warm water and a soft cloth.
3. Then use the water to rinse the inside parts, and drain out the water from the draining port by unplugging the drain cap on the back.
4. The outside of the ice maker should be cleaned regularly with a mild detergent solution and warm water.
5. Dry the interior and exterior with a soft cloth.
6. When the machine is not in use for a long time, open the water drain cap to drain water completely out from the water reservoir.
   After using your ice maker for a long time, we suggest you clean your unit.

Especially the water separator pipe and the water filters. These must be cleaned periodically.

1. If the water separator pipe is blocked, meaning there is no water flowing through, and the compressor and water pump inside are still working, please turn off the unit first and remove the pipe and clean it. Clean each hole on the pipe wall as displayed in the following picture. After cleaning, reinstall the water separator pipe and be sure the right terminal of the pipe connects to the silicone pipe well.
2. Both the water tank and water reservoir should be cleaned with diluted detergent, warm water, and a soft cloth. Then use water to rinse the inside, and drain out the water from the draining port by unplugging the drain cap on the back. It will help you keep the unit and newly made ice cubes clean and also help the unit function properly.
3. When cleaning, if you find that a ice cube is stuck on the evaporator and can’t be taken out easily, turn on the unit and let it begin the ice-making process. Then press the “ON/OFF” button for more than 5 seconds to start the ice harvest process to melt the ice cube. This helps to remove a trapped ice cube.
   How to drain out the water from the internal tank and water reservoir
   If there is water in the reservoir and you want to drain away all the water, please plug in the unit, but don’t start it. Simply remove the drain port cap in the back. Wait a few minutes and all of the water will flow out.

USING YOUR ICE MAKER

Operation panel and display area

1. Remove the cover of the water reservoir and pour potable water into water reservoir.
   And be sure to keep the water level below the max level with the FULL mark displayed in the following picture. Then cloe the cover at once to avoid the entry of unwanted materials. Warning: Do not pour water into the internal water tank located underneath the ice basket. This tank is not big enough and will affect ice-making performance.

2. When you plug in the unit, the power symbol< > will flash. Press the <ON/OFF> button and it will start making ice cubes; the ice-making symbol< > will keep be visible. The left upper corner of the display area will show the ambient temp, i.e: 80℉ means the ambient temp is 80 ℉. After several minutes, this area will show a flashing number, this is the ice-making countdown, i.e: 10M means the ice-making process will finish in 10 minutes.

3. When ice maker harvests, this < > will flash. Water will flow from the top water reservoir to the bottom water tank through the solenoid valve, the < > will display. When the water in the bottom water tank is full. The symbol < will shut off, then the next ice-making cycle starts again. When there is no water in the water reservoir, the symbol < > will stay on. Turn off the unit and fill the water again, then restart the unit to make ice cubes. Or fill the water directly and wait 20mins, the unit will restart the process.
   Note: The ice-making cycle lasts about 13 to 25 minutes, depending on the room temperature.
   During first use and based on the initial water temperature, the ice-making time will be a little longer. In extreme room temperatures, ice-making time may vary, but will not exceed 35 minutes.
   If you think the ice cubes are not thick enough, during ice making process press the <+> and <-> to set the ice-making times. Press one time and the ice- making cycle will increase or decrease one min, 6 minutes at most in either direction. This will start for the next cycle.

4. When Ice Full symbol< >is on, the unit will stop. Take out the ice cubes inside and the unit will start working again.
   If you press the button <ON/OFF> more than 5 seconds, when the ice maker is working, the unit will start to harvest. Press the button<ON/OFF> and the unit will turn off. Timer settings
   Unit is on timer setting: When the unit is working, the timer setting is off. Unit is the off-timer setting: When the unit is off, the timer setting is on.
   Press the button, the display will show <1H>, then press <+> and <-> to adjust the desired time. When setting, the H will flash, after 5 seconds the H will remain on and unit will use your set time.

5. Water Drain: take off the drain plug cap on the back of unit. Take out the silicon plug, then drain the water inside. It is best to change the water every 24 hours and the clean unit every 3 days.

Warning
A. Make sure the water tank, water filter and water separator pipe are not blocked. Clean them if needed.
B. The water temperature will effect the ice-making process. Lower temperatures will make more ice cubes.
C. The cooler the outside temperature, the more ice cubes will be made.
D. Always use good quality water to ensure the pump works well. Bad quality water will cause pump noise but doesn’t affect the unit working.
E. The compressor will restart 3 minutes later if you turn off the unit.

TROUBLESHOOTING

restart the unit.