KAILIN LIGHTING 2W 3000K 1993 LED Bulb Instruction Manual
- June 6, 2024
- KAILIN LIGHTING
Table of Contents
Operation instruction of LED bulb
KAILIN LIGHTING CO., LTD.
ADD: Foxin Industrial District, DaLang Town, DongGuan City,
Guangdong,523792China.
TEL:+86-769-83110269/83201320/83201321 FAX:+86-769-83110279
www.kailinlighting.com
Installation
- The normal connection was used, just put the lamp base on the lamp holder directly, it is easier and faster.
- Turn off the power supply before installing or removing the lamp.
- Do not touch the lens or reflector when you install a lamp or adjust the position of a lamp.
- Lamps can be used in enclosed fittings.
- Lamps are not to be used outdoors or in wet or extreme environments.
Cautions
- Please dispose of non-working electrical equipment to an appropriate waste disposal center.
- The packaging of this product is recyclable; please dispose of it inappropriate recycling receptacles.
- LED bulb suitable for Non-dimmable
- LED bulbs are not suitable for use under moisture.
KAILIN KLLT20F-2
2W 3000K CRI:80
120V 60Hz 28mA 100lm
CAUTION: SUITABLE FOR DAMP
LOCATIONS.MADE IN CHINA
Conforms to UL Std.1993
Certified to CSA Std.C22.2 No.1993
WARNING
Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance of 20cm between the radiator and your body.
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
NOTE: This equipment has been tested and found to comply with the limits for
Class B digital devices, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio or television reception.
However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment causes harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>