Gateman GM101 SS Single and Double Cylinder Deadlock Instruction Manual
- June 13, 2024
- Gateman
Table of Contents
INSTRUCTIONS FOR INSTALLATION OF
SINGLE AND DOUBLE CYLINDER DEADLOCKS
Door thickness 35-50mm
MARK DOOR
A. Fold and apply template to high edge of door bevel and mark center of door edge as indicated on template at the desired height from the floor. B. Mark center hole on door face through guide on template for either 2-3/8″ (60mm) or 2-3/4″ (70mm) backset.
DRILL HOLES
A. Drill thru door face as marked for lockset: It is recommended that holes be drilled from both sides to prevent spliting. Hole size is 2” (50.8mm) for standard installations. B. Drill 1°(25mm) hole in center of door edge thru to 2″(50.8mm) hole for latch.
INSTALL LATCH
A. Insert latch in hole keeping it parallel to face of door. Mark outline and
remove latch.
B. Chisel 1/8″ deep or until
latch face is flush with door edge. C. Install deadbolt latch in up position
into hole as shown latch insert and tighten screws. 
D. For round face deadbolt press flush to door edge Bolt must for
be vertically aligned with door edge as indicated by arrow.
INSTALL STRIKE
A. Bore 1” hole 1″minimum deep for deadbolt. B. Mortise 1/16″ deep for strike locating from 1″ hole in door insert and tighten screws.
INSTALL EXTERIOR MECHANISM
A. Press cylinder side flush against door making certain the torque blade is
properly positioned in latch crank.
B. Tapped holes in mounting plate of exterior cylinder should be lined up with
latch holes. Key hole should be in down position. TORQUE BLADE SHOULD BE
HORIZONTALLY INSERTED INTO LATCH CRANK
INSTALL INTERIOR MECHANISM
A. Slide thumb bar and interior rosette onto torque blade.
B. Insert machine screws through holes engaging holes in cylinder
and tighten.
INSTRUCTIONS FOR INSTALLING DOUBLE CYLINDER DEADLOCKS
Exterior half is fully assembled with exterior torque blade NOTE: This
assembly is placed through latch first.
A. Install interior cylinder
NOTE: The interior
torque blade is inserted into the exterior blade.
B. Press interior assembly flush against door making certain the torque blade
is properly positioned in latch hole. Key hole should be in down
position.
C. Insert(2) two screws
through countersunk holes engaging holes in exterior cylinder and
tighten.
FOR OPTIONAL ADJUSTABLE LATCH
– Backset is set at the factory at 2-3/8″ (60mm). To adjust latch to 2-3/4″
(70mm) position, hold rear of latch and rotate latch case 1/2 turn pulling
front of latch forwarder until pin snaps into the 2-3/4″ (70mm) position. To
return the latch to the 2-3/8″ (60mm) position repeat above, but push back
with thumb on the latch bolt and push latch bolt and latch case in
simultaneously.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>