MORRIS MHT-60038 Telescopic Cooker Hood User Manual

: June 5, 2024
: MORRIS

Table of Contents

MORRIS MHT-60038 Telescopic Cooker Hood
Checking instructions
Installation
USE
CARE & MAINTENANCE
FAQS
DECLARATION OF CONFORMITY
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

MORRIS MHT-60038 Telescopic Cooker Hood

Checking instructions

These instructions are for your safety. Please read the following instructions carefully before proceeding with the installation and use of this appliance.

WARNING :

All installation work must be carried out by a suitably qualified person, strictly following local building regulations and these instructions.
To avoid the risks that are always present when you use an electrical appliance it is important that this cooker hood is installed correctly and that you read the safety instructions carefully to avoid misuse and hazards. After unpacking the cooker hood please check that it is not damaged. If in doubt, do not use the appliance but contact Customer Services.
Check the package and make sure you have all of the parts listed and decide upon the appropriate location for your product. If this product contains glass please take care with fitting or handling to prevent personal injury or damage to the product.
The specification plate shown on this appliance displays all the necessary identification information for ordering replacement parts.
If you sell the appliance, give it away, or leave it behind when you move house, please ensure that you pass on this manual so that the new owner can become familiar with the appliance and its safety warnings.

Safety

WARNING :

Use only the same size of fittings and mounting screws as recommended in this instruction manual.
Switch off the appliance at the mains supply before carrying out any maintenance work or cleaning.
This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision. Keep the appliance and its supply cord out of the reach of children less than 8 years old.
Accessible parts may become hot when used with cooking appliances.Care should be taken to avoid touching the appliance.
Do not flambé under the hood.
The minimum safety distance between the cooker top and the extractor hood is: for gas hob 650mm and for electrical hob follow Instruction Manual template.If the instructions for installation for the gas hob specify a greater distance, this must be respected.
Means for full disconnection must be incorporated in the fixed wiring in accordance with the local wiring installation rules for your country. An all-pole disconnection switch having a contact separation of at least 3mm in all poles should be connected during installation.
Consult local regulations regarding extraction outlets and ensure these are complied with. Do not connect the hood to a ventilation or hot air duct containing combustion fumes from burning gas or other fuels. Confirm that room ventilation is appropriate with the local authorities.
There is a fire risk if cleaning is not carried out in accordance with the instructions. Refer to the Care and Maintenance sections carefully for details on how to clean and replace the aluminium and carbon filters (if fitted).
Refer to the Care and Maintenance section for details on the type of lamps that can be used and how to replace them.
Do not use a steam cleaner for care and maintenance.
There shall be adequate ventilation of the room when the hood is used at the same time as appliances burning gas or other fuels. Ensure that the negative pressure of the installation site does not exceed 4 Pa (0.04 mbar) to ensure combustion fumes are not drawn back into the room.
Do not use the hood if it shows signs of damage or imperfection. Contact customer services for assistance.
The appliance is for domestic use only as an extractor hood.

Installation

All installation must be carried out by a competent person or qualified electrician. Before connecting the mains supply ensure that the mains voltage corresponds to voltage on the rating plate.
The appliance must be connected directly to the mains using an omnipolar circuit breaker with a minimum opening of 3mm between the contacts.The installer must ensure that the correct electrical connection has been made and that it complies with the wiring diagram. The cable must not be bent or compressed.
Regularly check the power plug and power cord for damage. If the supply cord is damaged, it must be replaced by a special cord or assembly available from the manufacturer or its service agent in order to avoid a safety hazard.
The manufacturer declines all liability for personal or material damage as a result of misuse or incorrect installation of this appliance.

WARNING:

This is a Class II appliance and MUST NOT be earthed. This appliance is supplied with a 2 core mains cable coloured as follows:

Brown = L or Live
Blue = N or Neutral.

WARNING:

This is a Class I appliance and MUST be earthed. This appliance is supplied with a 3 core mains cable coloured as follows:

Brown = L or Live
Blue = N or Neutral
Green and Yellow = E or Earth ****

USE

CARE & MAINTENANCE

Warning:

Always switch off the electricity supply before carrying out maintenance work on the hood. In the event of a fault, contact an official distributor or authorised service center.
Cleaning the outside: use liquid, non-corrosive detergent and avoid using abrasive cleaning products and solvents.Do not use high-pressure or steam cleaning devices.

Important:

Increase the filter cleaning/replacement frequency if the hood is used for more than 2 hours a day. Always use genuine filters from the manufacturer.

Grease cleaning

To avoid fires, clean thoroughly once a month or whenever the display pilot light indicates such.
To do so, remove the filters and wash with hot w ater and detergent. If using a dishwasher (metal parts may turn black without this affecting their functional capacity), load the filters vertically to avoid solid residue from being deposited.

1 MONTH

FAQS

NOTICE ABOUT RECYCLING

Your product is designed and manufactured with high quality materials and components which can be recycled and reused. This symbol means that electrical and electronic equipment, at their end-of-life, should be disposed of separately from your household waste. Please dispose of this equipment at your local community waste collection/recycling centre.In the European Union there are separate collection systems for used electrical and electronic products. Please help us to conserve the environment we live in!