Nedlands Group ID-S-8W-CC LED SMD Downlights Remote Driver Instruction Manual
- June 15, 2024
- Nedlands Group
Table of Contents
Nedlands Group ID-S-8W-CC LED SMD Downlights Remote Driver
Important Safety Instructions
Basic safety precautions should always be followed when installing, including the following:
- Read all instructions.
- Licensed electrician for installation only.
- Always ensure the power is OFF and the fitting has cooled down before performing any maintenance, cleaning, changing the globe or adjustment to the fitting.
- Do not install any luminaire near the heat source.
- Do not exceed the nominal supply voltage or amperage ratings.
- To avoid injury or damage to the fitting, please ensure that power leads and screws are secure before connecting the power.
- The product is IC-4 luminaire.
Installation Instructions
RISK OF FIRE – Required clearance from structural members and building
elements
SCB=25mm HCB=25mm MIC=0mm SCI=0mm
- HCB : Height clearance to a building element
- MIC : Minimum insulation clearance
- SCI : Side clearance to insulation
- SCB : Side clearance to a building element
Warning:
Product modification and improper installation are not valid for warranty!
WARNING -RISK OF OVERHEATING OR FIRE IF THE CLEARANCE DISTANCES ARE
COMPROMISED nonreplaceable light source which is a nonreplaceable part of the
luminaire either because it cannot be replaced without breaking or destroying
the luminaire or because it is enclosed under a cover fixed by screw or
similar fixing means designed to be used only once and which is not possible
to be opened.
For type Y attachments:
suppose the external flexible cable or cord of this luminaire is damaged. In
that case, it shall be exclusively replaced by the manufacturer or his service
agent or a similarly qualified person to avoid a hazard.
NOTE : Before installation, please check the IP label on the luminaire to
choose the right place to install it.
NOTE : Before installation, please check the driver’s information as
below.
WARNING
- Switch off before installation.
- Switch on only after complete installation and examination of the circuit.
- Professional electrician for installation and maintenance only.
- This solution requires that the number of single-channel parallel lamps cannot over 30PCS.
Turn Off the power supply before starting any installation. Read the instructions & check you have all the tools & accessories to complete the installation correctly.
Downlight with internal driver
For the product with Slide Switch of CCT Selection, please select the light 3CCT(WW/NW/CW)before installation.
1800 909 306
nedlandsgroup.com.au
sales@nedlandsgroup.com.au
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>