ocresources mirror assembly Instructions
- June 5, 2024
- DocResources
Table of Contents
ocresources mirror assembly
USER INSTRUCTION
User instruction for hanging-supports
By individually sticking the hanging-supports to the back of the mirror you can the joints of the tiles in your bathroom Please make sure that there are no tubes or electrical parts in the wall where you have to drill the holes. In order to ensure that the self-adhesives stick firmly to the back of the mirror please keep the foreseen positions clean from dust, fat or oil.
- fix the exact position of the hanging-supports .
- remove the protection-foil from the self-adhesive pad of the hanging-support (do not touch the adhesive surfaces).
- press the hanging-support firmly onto the exact position.
- ATTENTION: it is not possible to re-arrange the position after pressing.
- wait approximately 12 hours before hanging the mirror on the wall.
- the best processing temperature is between 25° +/-5° Celsius
- Please avoid the contact with water, otherwise the adhesive tape loses adhesion.
User instruction for glue-mirrors
In order to ensure that the self-adhesives stick firmly to the back of the
mirror please keep the foreseen positions clean from dust, fat or oil.
- please place the mirror just on flat and even surfaces
- remove the protection-foil from the self-adhesive pad of the hanging-support (do not touch the adhesive surfaces).
- ATTENTION: it is not possible to re-arrange the position after pressing
- the best processing temperature is between 25° +/-5° Celsius
- Please avoid the contact with water, otherwise the adhesive tape loses adhesion.
FOR WALL MIRRORS AND GENERAL FRAME MIRRORS
Mirror with groove
Please use at least 2 screws / hooks! If you assemble a mirror with a length
from 160cm and more, please use minimum 3 screws or hooks.
Important: Please do not screw the hooks more than 3 cm from the
outerside of the frame.
Fitting the screws into the wall
Fitting the screws with measurement equipment into the wall