Shenzhen You Me Electronics YM-UD09 Wireless Charging Station Instruction Manual
- June 5, 2024
- Shenzhen You Me Electronics
Table of Contents
Shenzhen You Me Electronics YM-UD09 Wireless Charging Station
Package Contents
- Charging station base
- 5Clear plastic dividers
- 1 AC power cable
- Instruction manual
Specifications
Installation
First install the four clear plastic dividers on the charging base. Notice
that each divider has a center slot at the bottom with a cut like a “U” shape.
Flip the divider and match its slots with the slots on the base. Then gently
press it into the base until you hear or feel a click.
Light on/off Switch
Notice there is a button to the side of the charging station for you to switch the light on and off. When you connect the AC power cable to the outlet and push the button inward, you should see a blue light turns on. And during bedtime, you may also use this soft blue light as a night light if you wish.
Cleaning Instruction
If you have a lot of dust in your room, some of the dust might get trapped on the black surface of the charging station. You may use a dry or damp cloth to wipe it off. If you use a damp cloth, make sure to unplug the cable from the power outlet before cleaning, and dry it up before plugging the power back.
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is Subject To
the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation. Changes or modifications not explicitly approved by the
party responsible for compliance could void the user’s authority to operate
this equipment.
Note: this equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. During the operation of device a distance of 15 cm surrounding the device and 20 cm above the top surface of the device must be respected.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>