GEMROCK PV-1152 IP67 Waterproof Speaker Instruction Manual
- June 5, 2024
- GEMROCK
Table of Contents
PV-1152 IP67 Waterproof Speaker
Instruction Manual
PRODUCT SPECIFICATIONS
- Bluetooth Version: 5.0+EDR
- IPX67 Certified
- Operating Distance: 33FT
- Output Power: 2 x 3 Watt
- Input: 5V/500mA, 3.5mm Aux, Micro USB
- Battery: 1200mAh
- Frequency Response: 20Hz-18KHz
- Driver: 40MM
- Charging: Approx 4.5 hour
- Playback: Approx 3 hours
- Dimensions (LxWxH): 193.5 x 37.5 x 80mm
PACKAGE CONTENTS
- Speaker
- Micro USB Charging Cable
- 3.5 mm Auxiliary Cable
- Carrying Strap
- User Manual
CHARGING DEVICE
Before using this speaker for the first time, charge for 24 hours.
- Plug the Micro end of the charging cable into the port on the speaker. Plug the USB end into a computer’s USB port or a compatible AC wall adapter.
- The red LED will turn on to indicate the device is charging.
- Once fully charged, the red LED will turn off.
When Battery is low, approximately 4-4.5 hours of charging time is needed to fully recharge the battery.
PAIRING THE DEVICE
- Place speaker within 30ft of Bluetooth-enabled device.
- Power On/Off: Press and hold the ON/OFF button for 2-3 seconds
- On your device’s Bluetooth menu, find and select “Rock Solid BT Speaker”. (you may be required to enter a password “0000”).
- The blue LED will flash slowly when the pairing is complete.
BASIC INSTRUCTIONS
To turn the speaker on, press and hold the ON/OFF button for 2-3 seconds. The speaker will beep and a blue LED will flash slowly. The blue LED will stay on when playing music. The speaker will beep every 20 seconds when the battery is low. To turn the speaker off, press and hold the ON/OFF button for 2-3 seconds.
LED INDICATOR
Charging: Red LED on
Fully Charged: Red LED of
Pairing Mode: Blue LED will flash quickly
Conn e cted: Blue LED on
Playing: Blue LED will flash slowly
SPEAKER BUTTON FUNCTIONS
-
Power On/Off: Press and hold the ON/OFF button for 2-3 seconds
-
Last song: Press quickly for the last song.
-
Next song: Press quickly for the next song.
-
Volume down : Press quickly to decrease the volume.
-
Volume up: Press quickly to increase the volume.
-
Play/Pause/Phone Answer and Redial Key
When you receive a call, press the button to answer/hang up. When the call ends, the music will resume playing. -
RESET: To reset the unit, press the “Reset” button.
-
AUX IN : 3.5mm audio input (line-in)
-
DC 5V: Use the included Micro USB cable to connect the device to a computer USB port/AC power adapter with USB to charge.
SAFETY INFORMATION
Do not attempt to disassemble the device. Doing so may result in an electric
shock. Do not use this device on an aircraft or in a hospital. Do not expose
this device to direct sunlight, heat, or open flame. The device may become
warm while charging.
CAUTION
Any changes or modifications to this device, not expressly approved by the
party responsible for the compliance, could void the user’s authority to
operate this device. This device and its antenna(s) must not be co-located or
operated in conjunction with any other antenna or transmitter.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- This device may not cause harmful interference
- This device must accept any interference received, including interference that may cause undesired operation.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>