Xiamen New Sound Technology SBW Wireless Charging Case User Manual
- June 5, 2024
- Xiamen New Sound Technology
Table of Contents
Xiamen New Sound Technology SBW Wireless Charging Case User Manual
Preface
Please read this user manual carefully before use. This user manual only applies to the wireless charging hearing aid series.
Function: Charging, drying, sterilization, storage
Input voltage: 5V 1.5A
Input current: 0.8A
Output current: 7-10mA
Charging time: 3-3.5 hours (A hearing aid with a capacity battery at 25mA
as an example)
Detection time: 5-10 seconds
Sterilization time: 30 minutes
Operation
Connect the power
- Plug the smaller end into the charging port of the base
- Plug the larger end with the provided adaptor.
- Plug the adaptor into a power outlet.
Open the charging case
Place the hearing instrument
- The end with dome of the instrument face and near the light for better sterilization.
- Place the instrument in each sides of the crossbar in the case.
Close the case to start charging
- The transmitting end automatically detects the hearing aid placed on the charging area of the case via Bluetooth. The detection time is 5-10 seconds.
- Once detected, the light will shine blue and system start charging.
- Close the case
NOTE: The case will also start the drying process after you close the case.
Charging indicator recognition
charging indicator
NOTE: Due to the inconsistency of their respective residual power, there is a certain difference in the time when the indicator turn green between two device.
Sterilization indicator
NOTE:
- If the case is not closed, the sterilization will not start.
- Once you open the case during sterilization, the process will restart and lasts 30 minutes.
FCC Regulatory Information
This device complies with Part 18 of the FCC Rules. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the equipment being interfered with.
- Increase the separation between the charger and the equipment subject to interference.
- Connect the equipment into an outlet on a circuit different from that to which the charger is connected.
- Consult the dealer or an experienced radio/TV/electronics technician for help.
CAUTION: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
FCC Supplier’s Declaration of Conformity
NewSound SBW01
NewSound Primo WA801
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Responsible Party in the USA:
IMHEAR CORPORATION
2711 Curtiss St. Suite B
Downers Grove, IL 60515
Contact: 001-630-395-9628
Xiamen NewSound Technology Co.,Ltd
Address: 1st and 2nd floor, No.13 of
Xiangyue Road, Torch Hi-Tech Industrial
Development Zone, Xiang’An District,
Xiamen, China.
Email: sales@usnewsound.com
