CISCO IG21 Industrial Gateway Installation Guide
- June 5, 2024
- Cisco
Table of Contents
IG21 Industrial Gateway
Installation Guide
IG21, IG21R, and IG31R Hardware
FCC and ISED Interference Statement
This equipment has been tested and found to comply with the limits for a Class
A digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense. FCC
Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this
equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that
may cause undesired operation. This device and its antenna(s) must not be co-
located or operating in conjunction with any other antenna or transmitter. For
products available in the USA/Canada market, only channel 1~11 can be
operated. Selection of other channels is not possible.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance 20cm between the radiator and your body. This device
contains license-exempt transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development Canada’s license-exempt RSS(s).
Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation.
This radio transmitter [IG21 IC: 2461N-IG21; IG31R IC: 2461N-IG31R ] has been approved by Innovation, Science and Economic Development Canada to operate with the antenna types listed below, with the maximum permissible gain indicated. Antenna types not included in this list that have a gain greater than the maximum gain indicated for any type listed are strictly prohibited from use with this device.
| Antenna type | Model Number | Antenna Gain (dBi) |
|---|---|---|
| Dipole | IG21 | 4. |
| Dipole | IG31R | TBD |
IG21, IG21R, and IG31R Hardware Installation Guide
FCC and ISED Interference Statement
| Antenna type | Model Number | Antenna Gain (dBi) |
|---|---|---|
| Dipole | IG21R | 4. |
| Dingle | TC711R | TAT) |
IMPORTANT NOTE:
ISED Radiation Exposure Statement:
This equipment complies with ISED RSS-102 radiation exposure limits set forth
for an uncontrolled environment. This equipment should be installed and
operated with a minimum distance of 20cm between the radiator & your body. The
transmitter module may not be co-located with any other transmitter or
antenna.
CAN ICES-3 (A)/NMB-3(A)
The Country Code Selection feature is disabled for products marketed in the
US/Canada For products available in the USA/Canada market, only channel 1~11
can be operated. Selection of other channels is not possible.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>