Marsk MS06 Karaoke Microphone User Manual
- June 5, 2024
- Marsk
Table of Contents
Marsk MS06 Karaoke Microphone
OVERVIEW
-
Charging interface
After connecting charging cable, it will automatically charge microphone, charging current is DC 5V, 500MA -
Play/Pause
Short press to play/pause -
Microphone volume button, press upwards to volume up, press downwards to volume down
-
On/Off button, “ON” is power on, “OFF” is power off.
-
Volume down, short press to volume down, long press to previous song
-
Mold/LED button:
-
Short press to switch molds, such as selfie, AUX, FM
-
Long press to turn on/off led light
-
U-disc: Insert U-disc to turn on U-disc mold, automatically play songs from U-disc.
-
Monitoring interface, connect it with headphones to monitor the effect of singing song.
-
TF Card： Insert TF card to automatically play music.
-
Remix volume button, press upwards to add remix volume,press downwards to reduce remix volume.
-
Volume up button, shore press to volume up, long press to next song.
-
Remove original singer’s sound, short press to remove original singer’s sound, press again to recover original singer’s sound.
Aux In-mold
Turn on Bluetooth, short press “M/LED” button for two times to turn on “Aux- In” mold. Pls insert the special line-in cable to charging interface, one end of line in cable
FM Mold
Turn on Bluetooth, short press “M/LED” button for three times to turn on FM function. Then short press “Play/Pause” button to automatically search broadcasting station, and short press “volume up/down” to select s If need to stop searching, pls short press “Play/Pause” again.
Selfie mold
- Turn on the Bluetooth of microphone, short press number 6 (M/LED button)
- Turn on Bluetooth of mobile, search “shutter” to connect the microphone
- Turn of the camera of mobile, short press microphone’s volume button to selfie.
Remark: Selfie function require the OS version of android mobile should be above 4.2.2 and IOS version should be above 6.0. But if mobile have the selfie button, this function will not be used.
FCC
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Any changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure statement.
The device can be used in portable exposure conditions without restriction
Warning: Changes or modifications to this unit not expressly approved by
the part responsible for compliance could void the user’s authority to operate
the equipment
2. Any Changes or modifcations not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>