Electrolux DGE5861HR Black Integrated Range Hood User Manual
- June 3, 2024
- Electrolux
Table of Contents
Electrolux DGE5861HR Black Integrated Range Hood
FOR PERFECT RESULTS
Thank you for choosing this AEG product. We have created it to give you impeccable performance for many years, with innovative technologies that helpmake life simpler – features you might not find on ordinary appliances. Please spend a few minutes reading to get the very best from it. Visit our website to:
- Get usage advice, brochures, trouble shooter, service, and repair information: www.aeg.com/support
- Register your product for better service: www.registeraeg.com
- Buy Accessories, Consumables and Original spare parts for your appliance: www.aeg.com/shop
CUSTOMER CARE AND SERVICE
Always use original spare parts. When contacting our Authorised Service Centre, ensure that you have the following data available: Model, PNC, and Serial Number. The information can be found on the rating plate.
- Warning / Caution-Safety information
- General information and tips
- Environmental information
subject to change without notice.
SAFETY INFORMATION AND INSTALLATION
WARNING: Refer to the separate installation Instructions booklet for safety information and Installation. Read carefully the Safetychapters before any use or maintenance of the appliance.
PRODUCT DESCRIPTION
Control panel overview
Function | Description | |
---|---|---|
1 | Hob²Hood | Indicator of the function to control hood from hob. |
2 | Lamp | Turns the lights on and off. |
3 | First speed / Off | The motor switches to first speed level. Second press |
turns off the appliance.
4| Second speed| The motor switches to the second speed level.
5| Third speed| The motor switches to third speed level.
6| Maximum speed| The motor switches to maximum speed level.
7| Filter notification| Reminds to change or clean the charcoal filter and
clean the grease filter.
DAILY USE
Using the hood
Check the recommended speed according to the table below.
While heating up food, cooking with covered pots.
While cooking with covered pots on multiple cooking zones or burners,
gentle frying.
While boiling, frying big quantities of food without a lid, and cooking on
multiple cooking zones or burners.
While boiling, frying big quantities of food without a lid, big
humidity. The hood operates on maximum speed. After 6 minutes the appliance
returns to the previous setting.
It is recommended to leave the hood operating for approximately 15 minutes after cooking.
To operate the hood
- Press the first speed button to switch on the appliance.
- If needed, press the light button to illuminate the cooking surface.
- If needed, change the speed by pressing the desired button. To turn off the appliance press the first speed button again.
Hob²Hood function
It is an automatic function that connects the hob to a hood. Both the hob and the hood have an infrared signal communicator. The speed of the fan is defined automatically on basis of the mode setting and the temperature of the hottest cookware on the hob. You can also operate the fan using the hob manually. The function can be activated from a panel of the hob.
For more information on how to use the function refer to the hob user manual.
Filter notification
The filter alarm reminds to change or clean the charcoal filter and clean the grease filter. The filter indicator is turned on for 30 seconds if the grease filter must be cleaned. The filter indicator flashes for 30 seconds if the charcoal filter must be replaced or cleaned.
ATTENTION
- Refer to cleaning the grease filter in the care and cleaning chapter.
- Refer to cleaning the charcoal filter or replacing the charcoal filter in care and cleaning chapter.
To reset the function press the button for 3 seconds.
To activate or deactivate the function
- To activate the function press the button for 3 seconds. If the function is activated, the indicator flashes two times.
- To deactivate the function press the button for 3 seconds.
If the function is deactivated, the indicator flashes ones.
Remote-control
The appliance is supplied with a remote control. The connection is originally enabled.
To connect or disconnect remote-control
- Switch off the appliance.
- Press the for 3 seconds.
The indicator on the control panel flashes twice if the function is enabled and once disabled.
CARE AND CLEANING
Notes on cleaning
Cleaning Agents
| Do not use abrasive detergents and brushes.
Clean the surface of the appliance with a soft cloth with warm water and mild detergent.
---|---
After cooking some parts of the appliance can get hot. To avoid stains
appliance must be cooled down and dried with a clean cloth or paper towels.
Clean stains with a mild detergent.
Charcoal filter
The time of saturation of the charcoal filter varies depending on the type of cooking and the regularity of cleaning the grease filter. The activated charcoal filter is not washable, cannot be regenerated, and must be replaced approximately every 4/6 months of operation, or more frequently for particularly heavy usage.
Cleaning the grease filter
Filters are mounted with the use of clips and pins on the opposite side.
To clean the filter
- Press the handle of the mounting clip on the filter panel underneath the hood (1).
- Slightly tilt the front of the filter downwards (2), then pull. Repeat the first two steps for all filters.
- Clean the filters using a sponge with nonabrasive detergents or in a dishwasher.
- The dishwasher must be set to a low temperature and short cycle. The grease filter may discolor, it has an influence on the performance of the appliance.
- To mount the filters back follow the first two steps in reverse order. Repeat the steps for all filters if applicable.
Replacing the charcoal filter
WARNING: The charcoal filter is non-washable!
To replace the filter
- Remove the grease filters from the appliance. Refer to “Cleaning the grease filter” in this chapter.
- Press the front edge in slot toward the bottom part of the filter. Slightly tilt the front of the filter downwards.
- To install a new filter, perform the same steps in reverse order.In any case, it is necessary to replace the filters at least every four months.
Replacing the lamp
This appliance is supplied with a LEDlamp and separate control gear (LEDdriver). These parts can be replaced by a technician only. In case of any malfunction refer to “Service” in the”Safety Instructions” chapter.
ENVIRONMENTAL CONCERNS
Recycle materials with the symbol . Put the packaging in relevant containers to recycle it. Help protect the environment and human health by recycling waste of electrical and electronic appliances. Do not dispose of appliances marked with the symbol household waste. Return the product to your local recycling facility or contact your municipal office.
References
- Welcome to AEG
- AEG - aeg.com
- Welcome to AEG
- Welcome to AEG
- Register your Electrolux appliance | Electrolux
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>