hmd Global BH405 Power Earbuds Lite User Guide
- June 5, 2024
- hmd Global
Table of Contents
Global BH405 Power Earbuds Lite
User Guide
What’s in the box
- Charging Case
- USB Type-C cable
- Earbuds (L/R)
- Quick Start Guide
- Ear Tips (S/M/L)
Product Overview
Charging case:
-
Charging contact
-
Charging contacts CL)
-
Battery status LEDs
-
USB Type-C port
Earbuds: -
Touchpad
-
LED indicator light
-
Microphone
-
Ear tip
Get started
- Before using Nokia Power Earbuds Lite, take off the film on the earbuds and place the earbuds back in the charging case. Then connect the USB Type-C cable to a power source to begin charging. Fully charge the earbuds and the charging case before the first use.
The battery status LEDs show the current battery status. 
- Earbuds LED indicator lights to turn red when charging, and turn off when fully charged. If the earbud is low in battery power, the LED indicator light will keep flashing red.
- For optimal fit and audio performance, replace the ear tips with the size that best suits you.
Pair and connect with Bluetooth
-
Pairing with the device
a. Turning on and Pairing:
When you take the earbuds out from the charging case, the earbuds will turn on and pair with each other automatically. When they have successfully paired, the LED indicator light of the right earbud will flash blue and red alternately and the earbuds are ready to connect with your Bluetooth® device.
b. Connecting with your Bluetooth device:
Turn on Bluetooth on your device and choose “Nokia Power Earbuds Lite” from the Bluetooth menu to connect.
During the connection process, the LED indicator light on the right earbud will flash blue and red alternately.
The LED indicator lights of the
earbuds will flash blue every 5 seconds when they are successfully connected
via Bluetooth. 
-
After the initial pairing, the earbuds will automatically connect with your Bluetooth device whenever taken out of the charging case.
-
The earbuds will automatically power off if there is no Bluetooth connection within 5 minutes.
Using your earbuds
-
Touch control:
****
Play / Pause music| x 1
Answer / End calls| x 1
Reject calls| 1 sec
Activate voice commands| 2 secs
Volume down| x 2| Volume up| x 2
Previous track| x 3| Next track| x 3 - Additional controls:
a. Manually power on and off:
Touch the touchpad of two earbuds for 3 seconds to manually power on; touch the touchpad of one earbud for 5 seconds to manually power off.
b. Use a single earbud:
You can single-use the right earbud. If the earbuds have been paired with your Bluetooth device before, the right earbud will automatically connect with your device when taken out of the charging case.
c. Reset to the original settings:
Put the earbuds back in the charging case (the LEDs will turn red) > Touch the touchpad of two earbuds for 5 seconds until the LEDs flash blue and red alternately 3 times indicating that the reset is successful.
Product and safety information
Remote control functions may vary depending on the model of your device and application. Soundtrack instructions do not respond to iOS devices. Since devices with Bluetooth wireless technology communicate using radio waves, they do not need to be in a direct line of sight. Bluetooth devices must, however, be within 10 meters (33 feet) of each other, although the connection may be subject to interference from obstructions such as walls or from other electronic devices.
- Frequency Band: 2400 MHz – 2483 MHz
- Maximum Radio Frequency Power: -6—+4dBm
For your safety
Important: Read these simple guidelines. Not following them may be
dangerous or against local laws and regulations. For further info, read the
complete user guide.
Switch off in restricted areas
Switch the device off when a Bluetooth headset use is not allowed or when it
may cause interference or danger, for example, in aircraft, in hospitals, or
near medical equipment, fuel, chemicals, or blasting areas. Obey all
instructions in restricted areas.
Interference
All wireless devices may be susceptible to interference, which could affect
performance.
Batteries, chargers, and other accessories
Use only batteries, chargers, and other accessories approved by HMD Global Oy
for use with this device. Do not connect incompatible products.
Protect your hearing
To prevent possible hearing damage, do not listen to high volume levels for
long periods.
Hearing
Warning: When you use the headset, your ability to hear outside sounds may
be affected. Do not use the headset which can endanger your safety. The
surface of this product is nickel-free.
Small children
Your device and its accessories are not toys. They may contain small parts.
Keep them out of the reach of small children.
Take care of your device
Handle your device with care. The following suggestions help you keep your
device operational.
- Keep the device dry. Precipitation, humidity, and all types of liquids or moisture can contain minerals that corrode electronic circuits.
- Do not use or store the device in dusty or dirty areas.
- Do not store the device in high temperatures. High temperatures may damage the device or battery.
- Do not store the device in cold temperatures. When the device warms to its normal temperature, moisture can form inside the device and damage it.
- Do not open the device other than as instructed in the user guide.
- Do not drop, knock, or shake the device or the battery. Rough handling can break it.
- Only use a soft, clean, dry cloth to clean the surface of the device.
- Do not paint the device. Paint can prevent proper operation.
- The earbuds are featured with a water protection level of IPX7. Water protection level is not a permanent condition and can decrease over time.
- The charging case is not water-resistant.
Recycle
** Always return your used electronic products, batteries, and packaging
materials to dedicated collection points. This way you help prevent
uncontrolled waste disposal and promote the recycling of materials. Electrical
and electronic products contain a lot of valuable materials, including metals
(such as copper, aluminum, steel, and magnesium) and precious metals (such as
gold, silver, and palladium). All materials of the device can be recovered as
materials and energy.
Crossed-out wheelie bin symbol
The crossed-out wheeled bin symbol on your product, battery, literature, or
packaging A& reminds you that all electrical and electronic products and
batteries must be taken to separate collections at the end of their working
life.
Do not dispose of these products as unsorted municipal waste: take them for
recycling. For info on your nearest recycling point, check with your local
waste authority.
Battery info
Your device has an internal, non-removable, rechargeable battery. Do not
attempt to remove the battery, as you may damage the device. The battery can
be charged and discharged hundreds of times, but it will eventually wear out.
Charging time can vary depending on device capability.
Battery safety
If left unused, a fully charged battery will lose its charge over time.
Always keep the battery between 15°C and 25°C (59°F and 77°F) for optimal
performance. Extreme temperatures reduce the capacity and lifetime of the
battery. A device may temporarily stop working if its battery is too hot or
too cold.
Do not dispose of batteries in a fire as they may explode. Obey local
regulations. Recycle when possible. Do not dispose of as household waste. Use
the battery for its intended purpose only. Improper use of, or use of
unapproved or incompatible, batteries may present a risk of fire, explosion,
or another hazard, and may invalidate any approval or warranty. If you believe
the battery is damaged, take it to a service center or your local shop before
continuing to use it. Never use a damaged battery. Do not charge your device
during a lightning storm.
Implanted medical devices**
To avoid potential interference, manufacturers of implanted medical devices
recommend a minimum separation of 15.3 centimeters (6 inches) between a
wireless device and the implanted medical device. Persons who have such
devices should:
- Always keep the wireless device more than 15.3 centimeters (6 inches) from the medical device.
- Do not carry the wireless device in a breast pocket.
- Switch the wireless device off if there is any reason to suspect that interference is taking place.
- Follow the manufacturer’s directions for the implanted medical device.
If you have any questions about using your wireless device with an implanted medical device, consult your health care provider.
Copyrights and other notices
The availability of products, features, apps and services may vary by region.
For more info, contact your dealer or your service provider. This device may
contain commodities, technology, or software subject to export laws and
regulations from the US and other countries. Diversion contrary to law is
prohibited.
The contents of this document are provided “as is”. Except as required by
applicable law, no warranties of any kind, either express or implied,
including, but not limited to, the implied warranties of merchantability and
fitness for a particular purpose, are made in relation to the accuracy,
reliability, or contents of this document. HMD Global reserves the right to
revise this document or withdraw it at any time without prior notice.
Reproduction, transfer, or distribution of part or all of the contents in this
document in any form without the prior written permission of HMD Global is
prohibited. HMD Global operates a policy of continuous development. HMD Global
reserves the right to make changes and improvements to any of the products
described in this document without prior notice.
Manufacturer and importer in EU: HMD Global Oy, Bertel Jungin aukio 9, 02600
Espoo, Finland. HMD Global Privacy Policy, available
at http://www.nokia.comiphones/privacy, applies to your use of the device.
In the unlikely event that this product is faulty, please return it to the
store where you purchased it with your proof of purchase. For more information
on this or other products please visit http://www.nokia.com/phones/suoport.
© 2020 HMD Global. All rights reserved. HMD Global Oy is the exclusive
licensee of the Nokia brand for phones & tablets. Nokia is a registered
trademark of Nokia Corporation.
The Bluetooth word mark and logos are owned by the Bluetooth SIG, Inc. and any
use of such marks by HMD Global is under license.
Declaration of Conformity
Hereby, HMD Global Oy declares that this product is in compliance with the
essential requirements and other relevant provisions of Directive 2014/53/EU.
A copy of the Declaration of Conformity can be found at www.Nokia.com/mobile-
declaration-of-conformity.
FCC Caution: Any changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority to operate
this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference. and
- This device must accept any interference received. including interference that may cause undesired operation.
This device and its antenna(s) must not be co-located or operating in
conjunction with any other antenna or transmitter.
NOTE: This equipment has been tested and found to comply with the limits
for a Class 8 digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates. uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions. may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception. which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consist of the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements. The
device can be used in portable exposure conditions without restriction
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>