Everspring SA370-2 USB DONGLE User Manual
- June 5, 2024
- EVERSPRING
Table of Contents
SA370-2 USB DONGLE
User Manual
Introduction
The SA370-2 is a Z-Wave Plus USB adapter to turn the PC or gateway into a
Z-Wave controller to manage multiple devices in the Z-Wave network. It’s fully
compatible with any Z-Wave-enabled network. Z-Wave-enabled devices displaying
the Z-Wave logo can also be used regardless of manufacturer. A Sigma driver
“CP210x VCP Drivers” and third-party software are required to operate this
device. A PC / notebook running ZWave software can control the Z-Wave network
through this USB.
Note: This is a hardware transceiver only. Third-party software needs to
be installed on your computer before using them as a Z-Wave Gateway.
Appearance
Installation
Plug the USB dongle into your PC or notebook and install all necessary drivers and software.
Troubleshooting
| Possible Cause| Solution
---|---|---
Unable to Pair| The device is controlled incorrectly.| See the device menu and
check the pairing procedures.
RF signal interference.| Operate again when there is no interference.
Pairing is booming, but the device cannot be
controlled or the device report cannot be received.| The maximum distance
between the USB dongle and the device has been exceeded.| Shorten the distance
between the USB dongle and the device.
RF signal interference.| Operate again when there is no interference.
Specifications
| Frequency Range | 908.4MHz/916Mhz |
|---|---|
| Operating Temperature Range | -10 to 50°C (Indoor use only) |
| Storage Temperature Range | -20 to 60°C |
| Humidity | 85%RH |
| Interface | USB |
| Operating Range | Up to 100m line of sight |
www.everspring.com
50 Sect. 1 Zhonghua Rd Tucheng
NewTaipeiCity 236 Taiwan..
Federal Communication Commission Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this
equipment.
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance of 20cm between the radiator & your body.
Industry Canada statement:
This device complies with ISED’s license-exempt RSS. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Radiation Exposure Statement:
This equipment complies with ISED radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance of 20cm between the radiator & your body.
WARNING:
Do not dispose of electrical appliances as unsorted municipal waste, use
separate collection facilities.
Contact your local government for information regarding the collection systems
available.
If electrical appliances are disposed of in landfills or dumps, hazardous
substances can leak into the groundwater and get into the food chain, damaging
your health and well-being.
When replacing old appliances with new ones, the retailer is legally obligated
to take back your old appliance for disposal at least free of charge.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>