Theefun 1165A RC Stunt Car User Manual
- June 5, 2024
- Theefun
Table of Contents
Theefun 1165A RC Stunt Car
INTRODUCTION
Thank you for choosing Theefun remote control toy products. To ensure correct use, please read the following instructions carefully before use and save it for further reference. Application This product contains electronic components, thus please do not use it in water or humid environments.
Specifications
- For the Stunt Car:
- Toy type: 2.4GHz 1/24 4WD RC car
- Max. speed: 7km/h
- Battery type: 3.7V/500mAh LiPo battery, 1.85Wh
- Running time: about 20 minutes
- Charging time: about 90 minutes
- Material: ABS+ PP+ TPR
- Size: 160 x 155 x 75mm
- Weight: 318g (with the battery)
- For the Remote:
- Battery type: 2 x 1.5V AA (not included)
- Remote control distance: about 20-30m
Package Contents
- 1x RC Car
- 1x Remote Controller
- 2x LiPo Battery
- 1x USB Charging Cable
- 1x User Manual
Charging the Car Battery
- Slide the switches located on both the stunt car and the remote controller to OFF position (if it has a switch).
- Open the battery cover using a crosshead screwdriver.
- Remove the battery out of compartment
- Connect the battery interface to the USB cable interface correctly (shown as the figure below. A
- Note: The indicator light of USB cable glows steady red during charging process while it turns off after the battery is fully charged.
Operation Instruction
Get the car preparedControler:
- First install the batteries for the car and remote controller correctly (make sure the batteries have sufficient power).
- Slide the power switch on both of them to ON position in turn.
- The stunt car is ready to go.
Notes:
When you turn on the remote controller (if the stunt car is not turned on),
the controller indicator will flash quickly and then turn off. If you turn on
the stunt car and remote controller in turn, the car front light will be
always on and the controller indicator will be off. Once you operate the
controller, its indicator will light up; once you stop operation, it will
light off.
Other Important Notes:
When the stunt car runs low power, it will stop running or function
abnormally. Please charge the car battery in time. If you want to realize the
flip function, do not drive it on smooth ground.
Functional Demonstration
- Push both levers upward and the car will drive forward.
- Push both levers downward and the car wil drive backward.
- Push the left lever upward and the right lever downward, then the car will spin around
- Push the left lever down and the night lever upward then the car will spin around.
- First push both levers upward to drive the car forward, then push the left lever downward to let the car roll forward.
- First, push both levers downward to drive the car backward, then push the right lever upward to let the car roll backward.
- Once and spins you push to the the the right-left lever upward, upward, when moves
- Once you push the right lever upward the left wheel moves and spins to the left.
- Push both levers upward and downward at the same time. the wheels wil spin forward and backward at the same time.
Battery Safety Information
- If you won’t use the product for a long time, please remove the batteries from the remote controller and stunt car in time.
- Before using the USB charging cable, please carefully check whether its interface, socket and wire are in good condition.
- Before charging the stunt car battery, please make sure its interface and appearance are intact.
- The car battery must be charged under the supervision of an adut.
- Please wait at least 30 minutes to charge the car battery if it is just used up.
- When charging the car battery, ensure its interface has been correctly connected to the provided USB cable. Do not short-circuit it.
- Please turn off the power after using the product,
- Safely dispose of the used batteries in accordance with your local laws and regulations
Care and Maintenance
- Do not disassemble the device by yourself, otherwise it may lead to personal injuries and product damages.
- Keep the toy away from direct sunlight or heat sources.
- Wipe the toy gently with a clean damp cloth.
Brand Information
GREAT FUN FOR YOUR KIDS
Website: https://www.theefun.com/
Email: Support@theefun.com
Youtube:https://www.youtube.com/channel/UCDs9gbmfYHLgwbB6PEP-
idA/about?view_as=subscriber
FCC Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to corect the interference by one or more of the following measures
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
EU Declaration
Learn more about the EU Declaration of Conformity, Please click below link to download. http://files.theefun.com/w07-2173n-01-uk.pdf
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>