GENEVO GPS+ GPS Radar Detector User Manual

: June 5, 2024
: GENEVO

Table of Contents

Operating frequency:
Technical parameters:
Declaration of Conformity:
Database Updates:
Safety Instructions
Additional Information
Documents / Resources

USER MANUAL

GENEVO GPS+ GPS Radar Detector GPS Radar Detector GENEVA GPS+

Congratulations on your purchase of the world´s most intelligent radar and laser detector GENEVA GPS+.

Main functions of GENEVA GPS+:
GENEVA GPS+ was designed to detect radars via GPS module and it is possible to connect it wirelessly with a built-in radar antenna GENEVA HD+/HDM+. GENEVA GPS+ is designed to protect the driver from speeding fines. GPS+ communicates with drivers in English and its main functions are the detection of stationary radars, red light cameras and section speed cameras. In combination with GENEVA HD+/HDM+, you can detect even microwave radars (K / Ka narrow bands) and laser guns.
Notifications:
Text warning and voice alert appear on GENEVA GPS+ during radar alert. The strength of the signal and beeps express the intensity of the received signal. Signal strength has ten levels. GPS alerts are reported by voice. For example “Speed Camera”.

Control:

Left button MENU / ON-OFF
Short press: You will enter the setup menu. During radar alert you will mute the volume. The next alert will be reported again in the standard volume.
Long press: Turn ON / OFF GENEVA GPS+.
Right button SENSITIVITY / ADD YOUR OWN GPS POINT Short press: You can change the volume of GENEVA GPS+.

Long press: During normal operation: Add your own GPS point. During alert: If pressed during an alert you will mark the place of false radar reporting so at a given point detector will be suppressed during the next passage. If you suppress a false alert, the detector will not detect radars in a radius of about 150 meters. Hold the button during the „suppressed“ radar alert and this listing will be canceled. After next passage radar alert will be signaled normally.
Menu:
Press Left button to enter the menu.
Press Left button to go from one item to the next. To save any changes, simply wait a few seconds without pressing a button. The unit will display “Setting Completed” to confirm your selection.
Items in the menu are as follows:
(recommended settings are highlighted)
Brightness: Bright Dim Smart Dark Full Dark
Radar antenna: Radar Off / Genevo HD+ / Genevo HDM+
Sensitivity: (only if GENEVA HD+/HDM+ is connected): Highway / City / Auto City
Setting the speed in Auto City (item is present only if the sensitivity is set to Auto City): With the Left button, you are selecting between speeds for editing (number indicates the speed below which the detector will not respond to alerts. Right number indicates the speed below which the detector will detect alerts like in City mode). The right button changes the specific speed. For example, if the detector is set up to “20” and “50” the detector will not alert on radars till you reach 20 km/h speed. In the speed range from 20 to 50 km/h the detector will only respond to stronger radar signals. Maximum sensitivity will be reached at speeds above 50 km/h.
Setting City and Auto City sensitivity (entry is present only if the detector sensitivity is set to other than Highway): Via Left button you can select radar band for editing. To change the signal level on which the detector will start responding to radar signals use Right button. The level of suppression can be selected in the range 0-9. For example, when the setting is K2 and Ka2 the level of detection in all bands are slightly decreased.
Display Mode: Speed/Time, Speed/Voltage, Battery Voltage, Time, Speed, Compass
Auto Mute: On / Off: When activated, after two seconds of ongoing alert the volume will be reduced.
The minimum speed for signaling radar: Off, 10 km/h, 20 km/h, 30 km/h ……… .. 130 km/h
K-Band (only if GENEVO HD+/HDM+ is connected): Wide / Narrow / Instant on / Off
Ka-Band (only if GENEVA HD+/HDM+ is connected: Wide / Narrow / Off
Laser (only if GENEVA HD+/HDM+ is connected): On / Off
MRCT (only if GENEVA HDM+ is connected) : On / Off
MRCD (only if GENEVA HDM+ is connected): On / Off
Gatso (only if GENEVA HDM+ is connected): On / Off
Startup sound: On / Off
GPS connect announce: On / Off
GPS detection: On / Off
GPS warning distance: Normal (approx. 250 m) / Farther (approx. 375 m) / Farthest (approx. 500 m)
Setting local time: You can change the time zone via the Right button.
Language: Cesky / Deutsch / English
Rotate display 180°: On / Off
Factory reset: For reset press the Right button.
Delete all user points: For deleting all user points press the Right button.

Operating frequency:

GPS: SiRF STAR IV
ISM Band: 433.848 MHz ISM Band for paring HD+ (±50 kHz) receiver only

Technical parameters:

Operating temperature: -20 to +85 °C
Operating voltage: 11 – 16 V DC
Energy consumption: 140 mA normal, 200 mA max (12 V)
Power input : 2.4 W
Connector polarity: Positive
Power supply fuse: F2A/250V
Dimensions : 68 108 28 mm

Declaration of Conformity:

The manufacturer, GENEVA s.r.o., hereby declares that GENEVA GPS+ equipment complies with the essential requirements and other relevant provisions of Directive 2014/53/EU. The full Declaration of Conformity can be downloaded here: www.genevo.com/en/ce-gps.pdf

Database Updates:

The database update is recommended monthly. The download of the new database is performed according to the instructions at www.genevo.com/en/updates- support while at www.genevo.com/en /updates-subscription you can register and receive notifications of new and updated database to your email.

Safety Instructions

We recommend that you install the product using the included magnetic dashboard mount so that it does not obstruct your view. Alternatively, the product can be placed in another location provided it is securely fastened to prevent the device from moving by itself. The location must have good GPS signal reception. The device must be powered using the supplied 12 V cable (to be plugged into a 12 V plug in the vehicle) with a jack-type connector to be connected to the appropriately marked plug on the device.

Additional Information

Restrictions on placing in service or applicable requirements for permission to use:
Country: AT, BG, CY, DE, DK, EE, ES, FI, FR, GR, IR, ITA, LT, LU, LV, MT, NL, PL, PT, SE, SK.
Requirements: Please check your legislation before use.
Please note: The product may only be used for the purposes specified in this manual. Never use damaged equipment.
If you wish to discard electrical and electronic equipment, please contact your dealer or supplier for further information. GENEVO GPS+ GPS Radar
Detector - fig