PIMA ZEL508 Local Zone Expander Instruction Manual
- June 5, 2024
- PIMA
Table of Contents
ZEL508
Installation Instructions
| 1 | Mounting holes |
|---|---|
| 2 | RUN LED (card OK) |
| 3 | BUS LED (communication OK) |
| 4 | 8 Zone inputs |
| 5 | BUS connection cable |
| 6 | Technician keypad’s connection cable |
ZEL508 Local 8-Zone Expansion Card
ZEL508 is a local zone expansion card, designed for the FORCE security system.
It allows adding eight zone inputs to the FORCE’s eight onboard zones. The
card is installed on the control panel’s rack and connects to the BUS using a
special cable (supplied).
The ZEL508 has two flashing LEDs: RUN, which indicates that the card is
running OK, and BUS, which indicates that the card communicates over the BUS.
For complete information, see the FORCE’s Installation guide (P/N: 4410459).
Technical Specifications
- Zone inputs: 8 (can be EOL supervised)
- Operating Voltage Range: 10-15VDC
- Current Consumption: 30mA
- Sizes: 8.2 X 7.5cm
- Weight: 80gr
- CE compliance
- Operating Temperature: °C -10 to +55
Content of the product package
- ZEL508 expansion card
- Mounting screws (4)
- BUS connection cable
- This guide
How to mount and install the ZEL508
- Mount the expansion card on the control panel’s rack, to the left, on the four designated standoffs, using the supplied screws.
- Connect the supplied cable between one of the identical Molex sockets on the card (no. 5 or 6 on the above figure), and the FORCE BUS connector on the control panel.
- Use the other Molex connector on the card for connecting a technician keypad.
Ordering Information
- ZEL508: P/N 8330011
Limited Warranty
PIMA Electronic Systems Ltd. does not represent that its product may not be
compromised and/or circumvented, or that the Product will prevent any death,
personal and/or bodily injury, and/or damage to property resulting from
burglary, robbery, fire or otherwise, or that the Product will in all cases
provide adequate warning or protection. The User understands that a properly
installed and maintained equipment may only reduce the risk of events such as
burglary, robbery, and fire without warning, but it is not insurance or a
guarantee that such will not occur or that there will be no death, personal
damage and/or damage to property as a result.
Read this guide in its entirety before attempting to program or operate your
system. Should you misunderstand any part of this guide, please contact the
supplier or installer of this system.
Copyright © 2018 PIMA Electronic Systems Ltd. All rights reserved. E&OE
Manufactured by
PIMA Electronic Systems Ltd. WWW.PIMA-ALARMS.COM
5 Hatzoref Street, Holon 5885633, Israel.
Tel: +972.3.6506414 Fax: +972.3.5500442
Email: support@pima-alarms.com
P/N: 4410473
4410473
Revision: B, XX Multi, May 2022
References
- Alarms.com
- Pima Electronic Systems | Residential & Commercial Security Systems
- Pima Electronic Systems | Residential & Commercial Security Systems