Huajia Technology Industry RC1156 Remote Control Car Instruction Manual
- June 5, 2024
- Huajia Technology Industry
Table of Contents
Technology Industry RC1156 Remote Control Car
Instruction Manual
Remote Control Car
STUNT CAR:
TURN THE STUNT CAR ON/OFF BY PRESSING AND HOLDING THE POWER BUTTON.
SECTION 1
Watch Controller:
Turn the watch on/off by pressing and holding the power button.
SECTION 2
Click the finger button to switch between driving modes.
Double-click the finger button to switch the car to volume mode (for adjusting
volume).
Click the power button on the watch to pause play.
Click again to resume play. Press and hold the finger button for demo mode.
Release the button to resume normal play.
Note: The fourth LED (far right) will light up when charging and turn off
when charged. SECTION 3
Driving Mode 1:
In mode 1, the first LED (far left) will light up. The car will remain
stationary when the watch is kept level.
Tilt watch in any direction to make the car move accordingly. SECTION 4
Shake watch to raise and lower car body. SECTION 5
Driving Mode 2:
In mode 2, the second LED (middle left) will light up.
The car will remain stationary when the watch is kept level.
Tilt watch in any direction to make the car move accordingly.
In mode 2, the car will perform 360° spins when watching is tilted left and
right? SECTION 6
Shake watch to raise and lower car body. SECTION 7
In mode 3, the third LED (middle right) will light up.
This mode is for adjusting the car’s volume settings.
Tilt watch left and right to adjust the volume. Changes or modifications not
expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.