Huajia Technology Industry WJRC5106 2-In-1 2.4G Double Drive Stunt Car Instruction Manual
- June 5, 2024
- Huajia Technology Industry
Table of Contents
Huajia Technology Industry WJRC5106 2-In-1 2.4G Double Drive Stunt Car
Instruction Manual
|
---|---
Car: 4 X 1.SV AA batteries (not included)| Controller: 3 X 1.5V AAA batteries
(not included)
How to chance the tires:
Use screwdriver(pls ask adult for help)to unscrew the below position(arrow)for
interchange between wheels and crawler track.
CONTENTS
How to connect the car and controller?
Switch on the controller, you will see the red light flashing, then tum on the
switch on the car, you will see the red light on controller off, which means
that the car and the controller are successfully connected, if the red light
on the controller still flashes, it means the connection failed, please tum
off the switch and try again.
MADE IN CHINA
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful Interference In a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment Into an outlet on a circuit different from that to which the receiver Is connected.
- Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, enduring Interference that may cause undesired operation.