KIDZTECH 24GTX RC car Instruction Manual

: June 5, 2024
: KIDZTECH

Table of Contents

Contents
Battery Installation
How To Bind
How To Play
How To Fill In Water For Smoking Effect
How To Change To The Drifting Wheels
- Performance Tips
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

KIDZTECH 24GTX RC car

The 6.4V rechargeable battery pack must be charged before use by utilizing the USB charging cable which included
Do not overcharge the battery pack. Do not charge for more than 6 hours
Do not charge the battery pack if it shows leakage, corrosion, or has loose or exposed wires or other damage
Do not cover the battery pack with any sort of materials while charging
Do not touch the battery pack when it is hot. Wait until the battery pack cools before installing it in the Vehicle and before recharging
Do not dispose of the battery in fire
Do not dismantle the battery or charger, and do not cut the battery or USB charging cable
The battery pack will be warm after charging, and hot after use in a vehicle
The supply terminals are not to be short-circuited
Rechargeable batteries are to be removed from the toy before being charged
Rechargeable batteries for adult charging only
Battery replacement must be only made by adults
The USB charging cable is not a toy
Charge only type (1300mAh Max.) rechargeable battery packs. Other types of batteries may burst causing injury to persons and damage. This power unit is intended to be correctly orientated in a vertical or floor mount position. This USB charging cable is intended to be used for charging 6.4V rechargeable battery pack with capacity 1300mAh Max. It cannot be used for charging non-rechargeable batteries. Regular examination of USB charging cable for any damage to their cord, plug, enclosure and other parts, and that, in the event of such damage, it must not be used with the USB charging cable or battery pack charge until such damage has been repaired. Note that the 9V battery is non-rechargeable and is not to be recharged. Only batteries of the same or equivalent type as recommended are to be used. It will need replacement when transmission is poor.
Exhausted batteries are to be removed from the product.

Charging the Rechargeable Battery Pack for the Vehicle

Connect the 6.4V rechargeable battery pack to USB charging cable
Plug the USB charging cable into the standard AC socket (the equipment of class II or class III)
The charging time for a full charge is about 3 hours
When charging is completed, unplug the USB charging cable
Disconnect the rechargeable battery pack from the USB charging cable

Battery Installation

For Vehicle (Fig. 1 and Fig. 2)

Switch OFF the power
Unscrew the screw on the battery cover
Open the battery cover
Install 6.4V battery pack with correct polarities (+/-) as shown inside the battery compartment
Close the battery cover
Tighten the screw on the battery cover

For Transmitter (Fig. 3 and Fig. 4)

Unscrew the screw on the battery cover
Open the battery cover
Install 1 new 9V battery with correct polarities (+/-) as shown inside the battery compartment
Close the battery cover
Tighten the screw on the battery cove

How To Bind

Turn on the Vehicle.
Keep pulling the trigger of the Transmitter forward then turn the Transmitter on. Do not release the trigger until the binding process completed.
The LED light of the Transmitter will keep flashing for the binding process, which is within 8 seconds. Do not turn off any buttons while in progress, otherwise, the process will be terminated.
After the wheels of the Vehicle turn left and right and the LED light of the Transmitter stops flashing, the binding process completed for playing.
If it cannot complete within 8 seconds, please turn off both Vehicle and Transmitter and re-start the binding process.
When the binding process is done, whenever switching the Vehicle and Transmitter on and off, it searches for the code that it memorized, and will only lock on to the Transmitter signal containing that code.
Please turn off both Vehicle and Transmitter and re-start all binding process if changing to another 2.4GHz Transmitter for playing

How To Play

Switch ON the Vehicle and Transmitter.
Use the Steering Wheel to control the Vehicle turning left or right
Use the Accelerator Trigger to drive the Vehicle Forward, Stop and Backward
If the vehicle does not run in straight line, adjust the Direction Adjustment on the Vehicle chassis
Play on smooth surface to have the optimum performance
Remember to switch OFF the power of the Vehicle and Transmitter after playing
The optimum control range is up to 25m(82ft) outdoor

How To Fill In Water For Smoking Effect

Fill in clear water into the water pump.
Open the cap of water tank on the vehicle. (Fig.5 and Fig.6)
Fill in clear water to vehicle by using the provide water pump. (Fig.7)
Close the cap firmly. (Fig.8)

How To Change To The Drifting Wheels

Unscrew the screws of the rubber wheels on the vehicle.
Remove the screws and the wheels from the vehicle.
Install the drifting wheels into the vehicle.
Tighten the screws on the wheels.

Note: Changing wheels needs to be processed or supervised by the adult.

Performance Tips

Do not drive on grass, dirt, sand, dusts, carpet or go through water.
Do not drive in windy or rainy weather.
Avoid direct impact the Vehicle with obstacles.
Switch OFF the power when not in use to prevent damage of Vehicle and Transmitter due to leakage of electrolyte from batteries.
Remove all batteries from the Vehicle and Transmitter when not in use for long period.
Keep fingers, hair and loose clothing away from wheels.
The operating range can be affected by a variety of factors
a) Low Voltage of batteries in Transmitter or Vehicle
b) Interference from other items that emit radio frequency signals.
Outdoor usage is recommended in order to get optimum control range.
Recommend to play the vehicle on a clean and smooth surface.
Clean the battery compartment to make sure it is free from dust to prevent poor contact of batteries

Cautions

Do not attempt to disassemble the Vehicle or Transmitter
Make sure the batteries are installed with correct polarities (+/-) as shown inside the battery compartment
Remove the package and take out all accessories before giving the Vehicle and Transmitter to child to play

The packaging and instruction manual contain important information. Please keep them for future reference.
Warning! Choking Hazard. Not suitable for children under the age of 3 years due to small parts.
We reserve the right to improve/amend specifications and colors without notice.

FCC label compliance statement:

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:

This device may not cause harmful interference, and
This device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning theequipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
Consult the dealer or an experienced radio/TV technician for help

Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

RSS-210 Compliance Statement:
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).

Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the device.

Declaration of Conformity

The product is in conformity with the requirement of EU Directive 2014/53/EU.

Environmental notes:
The whole product also does not belong to household waste at the end ofthe product life.
You can return it at collection points for the recycling of electronic and electronical instruments
The symbol on the item, instruction manual, hangtag or packing is showing this clearly.
Materials should be recycled according to their respective markings.
Recycling of old devices or other re-use of materials contained therein represents an important contribution to environmental protection.
Please ask at your local community for the correct collection point.

Disposal of batteries
Batteries should not be disposed of in the household waste. As the consumer you are legally obliged to return batteries containing harmful substances and all other used batteries. You can hand in your old batteries at public collection points in your area or wherever batteries aresold.

You will find these chemical abbreviations along with a crossed-out refuse bin on batteries containing harmful substances:
Pb=Battery contains lead
Cd=Battery contains cadmium
Hg=Battery contains mercury

Ford Motor Company Trademarks and Trade Dress used under license to KidzTech Toys Manufacturing Ltd.

Frequency band: 2405-2475 MHz
Maximum radio frequency power transmitted: <0dBm

Conforms to the safety requirements of ASTM F963

KIDZTECH TOYS MANUFACTURING LTD.
Room 802, 8/F, Inter-Continental Plaza, 94 Granville Road, TST East, Hong Kong.
Tel: (852) 27218868 info@kidztech.net
Made in China http://www.kidztechtoys.com
US OFFICE:
1540 Forest Avenue, River Forest, IL 60305, USA
www.kidztechtoys.com Tel: 708-689-0085 Fax: 708-689-8172