Kidztech Toys Manufacturing 8316122-24GTX Remote Control Toy Transmitter Instruction Manual

June 4, 2024
Kidztech Toys Manufacturing

SLOT CAR TRACK SET – INSTRUCTION MANUAL
CHALLENGE LEVEL – 660CM / 21.6FT

Kidztech Toys Manufacturing 8316122-24GTX Remote Control Toy
Transmitter

NO. 83151 / 83161

LAYOUT

Kidztech Toys Manufacturing 8316122-24GTX Remote Control Toy Transmitter -
fig 1

CAUTION-ELERICTR: Not recommended fo children under 5 years of age. As with all electric products, precautions should be observed during landing and use to prevent electric shock. CAUTION SUOERNVISION RENNINENENIC101 RECI8IC101 UNPLUG WHEN I IN I. INPUT 100V
•125VAC 60Hz 0.410.5A OUTPUT: DC9V 1.5A

ASSEMBLY

Kidztech Toys Manufacturing 8316122-24GTX Remote Control Toy Transmitter -
fig 2

CONTENTS

Kidztech Toys Manufacturing 8316122-24GTX Remote Control Toy Transmitter -
fig 3

Kidztech Toys Manufacturing 8316122-24GTX Remote Control Toy Transmitter -
fig 4

TO PLAY

Control box – Battery installation (For B/O Version)

  1. Unscrew the screw on the battery cover.

  2. Open the battery cover.

  3. Insert new 6 x AA (1.5V) batteries into the battery compartment of the control box with the correct polarity (+/—).

  4. Close the battery cover.

  5. Tighten the screw on the battery cover.

Transmitter – Battery installation

Kidztech Toys Manufacturing 8316122-24GTX Remote Control Toy Transmitter -
fig 8

  1. Unscrew the screw on the battery cover.
  2. Open the battery cover.
  3. Insert new 2 x AAA (1.5V) batteries into the battery compartment of each transmitter with the correct polarity (+/—).
  4. Close the battery cover.
  5. Tighten the screw on the battery cover.

MAINTENANCE

Kidztech Toys Manufacturing 8316122-24GTX Remote Control Toy Transmitter -
fig 9

The packaging and instruction manual contains important information. Please keep them for future reference. We reserve the right to improve/amend specifications and colors without notice.

SAFETY

  1. Alkaline batteries are recommended to be used (For B/O Version)
  2. Only batteries of the same or equivalent type as recommended are to be used
  3. Do not mix alkaline, standard or rechargeable batteries
  4. Do not mix old and new batteries or different type of batteries
  5. Non-rechargeable batteries are not to be charged
  6. Rechargeable batteries for adult charging only
  7. Rechargeable batteries are to be removed from the product before they are charged
  8. Be sure to insert batteries with correct polarities and always follow the battery manufacturer’s instructions
  9. Remove all batteries when not in use
  10. Exhausted batteries are to be removed from the product
  11. The supply terminals are not to be short-circuited
  12. Dispose of batteries properly. Do not dispose of the batteries in a fire – it may cause them to explode or leak causing injury or damage
  13. Battery installation and removal must only be done by an adult

FCC label compliance statement:
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna
  • Increase the separation between the equipment and receiver
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
  • Consult the dealer or an experienced radio/TV technician for help

Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

RSS-210 Compliance Statement:
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science, and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device. ion. Declaration of Conformity
The product is in conformity with the requirement of EU Directive 2014/53/EU

The instructions for battery toys with replaceable batteries shall contain the substance of the following, as applicable:
Control box: AA batteries x 6 should be used.
Transmitter: AAA batteries x 4 (2 for each Transmitter) should be used.

Environmental notes:
The whole product also does not belong to household waste at the end of the product life.
You can return it at collection points for the recycling of electronic and electrical instruments The symbol on the item, instruction manual, hangtag or packing is showing this clearly. Materials should be recycled according to their respective markings.
Recycling old devices or another re-use of materials contained therein represents an important contribution to environmental protection.
Please ask your local community for the correct collection point.

Disposal of batteries
Batteries should not be disposed of in household waste. As the consumer, you are legally obliged to return batteries containing harmful substances and all other used batteries. You can hand in your old batteries at public collection points in your area or wherever batteries are sold. You will find these chemical abbreviations along with a crossed-out refuse bin on batteries containing harmful substances:
Pb=Battery contains lead
Cd=Battery contains cadmium
Hg=Battery contains mercury

THE PRODUCT MUST BE ASSEMBLED BY ADULTS ONLY.

HEITWHEELS.com
Kidztech Toys Manufacturing Ltd., Hong Kong.
MADE IN CHINA.
HOT WHEELS-and associated trademarks and trade dress are owned by, and used under license from, Mattel. ©2021 Mattel.
CONSUMER INFORMATION
KIDZTECH TOYS MANUFACTURING LTD.
Room 802. 8/F. Inter-Continental Plaza.
94 Granville Road. TST East. Hong Kong.
Tel: (852) 27218868 info@kidztech.net Made in China
http://www.kidztechtoys.com
US OFFICE: 1540 Forest Avenue.
River Forest, IL 60305. USA
Tel: 708-689-0085 Fax: 708-689-8172
PRODUCT: SLOT CAR TRACK SET
AGE GRADE: For ages over 5 years.
CONTENTS: All contents listed here.

Conforms to the safety requirements of ASTM F963

WARNING: CHOKING HAZARD – Small parts Not for children under 3 years

Kidztech Toys Manufacturing 8316122-24GTX Remote Control Toy Transmitter -
QR code

www.kidztechtoys.com

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals