QuFresh QFAP-950 3 Stage Filtration HEPA Tower Air Purifier Owner’s Manual
- June 5, 2024
- QuFRESH
Table of Contents
Owner’s Manual
QuFresh Air Purifier QFAP-950
FOR HOUSEHOLD USE ONL
| | |
---|---|---|---
SAFETY
This safety alert symbol is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death .
Danger indicates an imminently hazardous situation, which, if not avoided,
will result in death or serious injury.
Warning indicates a potentially hazardous situation, which, if not avoided,
could result in death or serious injury
SAFETY INSTRUCTIONS WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING
Caution indicates a potentially hazardous situation, which, if not avoided,
may result in minor or moderate injury.
Used to indicate an electrical shock or electrocution hazard
Safety Precautions
In order to avoid possible injury or financial loss to you or others, please
pay attention to the following safety precautions.
If the power cord is damaged, in order to avoid danger, it must be repaired by
the professional personnel of the manufacturer, its maintenance department or
similar departments.
Warning
Do not touch the power plug with , wet hands.
Electric shock may be caused.
Please plug the plug into the power socket before starting the air
purifier.
If the plug is not fully inserted into the socket, it may cause electric shock
and overheating, and possibly fire.
- Do not use damaged plugs or loose power outlets.
Do not disassemble or refit the air purifier. Disassembly or modification of electrical appliances may lead to electric shock, failure or fire.
Before cleaning the air purifier, make sure that the power supply has been disconnected.
Do not damage the power cord and socket. When using the machine, do not bind the wires. Using the damaged wires may lead to electric shock, short circuit or fire.
” Do not place rods or other metal objects at the air outlet or opening.
Otherwise, it may touch the internal parts and cause electric shock or damage
Product Introduction
Before Use
Removal and installation of side cover plate
- Hold the grooves of the left and right side panel covers by hand and pull them out at the same time.
- When re installing the side panel cover, align and insert the fixed groove, push the side panel cover close to the machine, and the side panel cover will automatically close to the machine.
Place of air purifier
Do not obstruct the air inlet and outlet to ensure adequate ventilation and
maximum efficiency of the machine.
In order to achieve good air circulation effect in your room, make sure that
the air inlet and outlet of the machine are not less than 20 in. away from the
obstacles. 
Install the filter assembly
All filters are attached to the air purifier, but the packing of the filter
must be removed before using the product. Please follow the instructions below
to remove the filter and its package, and then put it back into the purifier.
- Remove all packaging materials and place the machine on a dry, stable, level surface.
- Hold the groove of the left and right side plate cover with your hand and pull it out at the same time.
- Remove all filters inside the purifier.
- Remove all packing materials on the filter screen and put the filter screen back into the purifier.
- Re install the side cover, align and insert the fixed groove, and then push the side cover close to the machine, and the side cover will pull in automatically.
Filter purification
Step 1: Primary filtration
Step 2: H11 high efficiency filtration Step
3: Activated carbon filtration
-
Primary filtration
Remove large particles, including hair, fiber, dander, etc. -
H11 high efficiency filtration
It can effectively filter PM2.5, smoke, pollen, mites and other particles. -
Activated carbon filtration
High quality activated carbon, modified by special proprietary technology, can effectively purify formaldehyde and other gas pollutants.
Usage method
Function description of control panel
- Speed button
- Power button
- Timer button
- Child lock button
Plug in the power supply
When the power is plugged in, a long beep will sound and all the lightst will be on (except the air quality indicator) for 1 second. After that, the air quality indicator will be red for 0.5 second, green for 0.5 second, and blue for 0.5 second. Then the power indicator will be half on, and the machine will enter the standby mode.
Turn on the purifier
Press the on key (as shown in the figure), the air cleaner will be turned on. Within 10 seconds after the air quality sensor is just opened, the air quality sensor needs to warm up. After 10 seconds of operation, the air quality sensor will automatically and quickly identify the current air quality, and the current air quality can be reflected through the color and digital display of different air quality indicator lights.
| Blue| 000-075| Excellent
---|---|---|---
Green| 076-150| Good
Red| 151-999| Poor
Air volume setting
Fan speed, air volume can be 1, 2,3, or auto speed, (sleep) cycle selection.
Lock Function
Long press the child lock key for 3 seconds to prompt that the sound is on, and the machine enters the child lock mode. In the child lock mode, any key function is invalid. Long press the anion key again for 3 seconds to exit the child lock mode.
Timer setting
Timer, the machine can be selected in 2 hours, 4 hours, 6 hours, 8 hours.
Maintenance and cleaning
Be sure to unplug before cleaning the product. Do not immerse the product in
water or any other liquid. The composite filter screen shall not be washed.
Clean air purifier
Clean the inside and outside of the purifier body regularly to prevent dust
accumulation.
- Use a soft dry cloth to wipe the dust off the purifier.
- Clean the air inlet and outlet with a soft dry cloth.
Replacing the filter
When the indicator light on the filter reset key flashes slowly, the user is
reminded to replace the filter.
- Remove all filters from the machine and remove all packaging materials from the new filter.
- Install the composite filter into the machine.
- Replace the filter screen, reinstall the left and right side panels, and plug in the power plug.
Attention
Please shut down unit before replacing the filter.
The filter screen of this product is a composite filter screen, which is easy
to damage. The general service cycle is 6 months.
The above time is for reference only, users can change it according to the
actual use environment.
Troubleshooting
This chapter lists the common problems that may be encountered when using this product. If you are unable to solve the problem according to the information below, please contact the customer service center or the dealer.
| State | Possible causes | Possible solutions |
|---|---|---|
| The machine won’t start | The machine won’t start | Pull out the power cord and |
plug in again
The power cord is damaged| Contact customer service center or dealer
Fan not working| The machine is not on| Pull out the power plug and plug in
the power again
The motor is damaged| Contact customer service center or dealer
Foreign particles inside the machine| Contact customer service center or
dealer
Poor
performance
or sub-optimal
purification| The filter was not replaced| Replace a new set of filter
The air inlet or outlet of the machine is locked| Contact customer service
center or dealer
The plastic package of the filter is not removed| Remove the plastic package
of the filter screen for reuse
There is not proper clearance or space around
the machine to ventilate it| Make sure that the air inlet and outlet of the
machine are not less than 50cm away from the obstacles
There is no filter in the machine| Make sure that the filters are placed in
the machine in the order indicated
More than expected room coverage| Recheck whether the area of the used room is
consistent with the specified area of the machine
VENTAMATIC, Ltd.
LIMITED WARRANTY STATEMENT
This warranty is underwritten by Falco Insurance Company and is extended to
the original retail purchaser of this model or, if this unit is purchased and
requires installation by a building contractor, to the original owner of the
home. No subsequent purchaser of the unit or of a home in which it is
installed is entitled to any of the benefits of this warranty.
This product is warranted against defects in materials and workmanship for a
period of one (1) year from the date of original retail purchase. No other
parts or components are warranted.
There is no warranty for defects caused by abuse, faulty installation, or the
like.
Repairs or replacement parts supplied under this warranty are warranted only
for the period of this warranty; that is, one (1) year from the date of the
original retail purchase of the unit.
In the event of a defect or malfunction, we will replace or repair the
defective part or component only and return the new or repaired part to you
freight prepaid.
You must bear all other expenses incurred in obtaining repairs, including
labor required for field repair or replacement, and the cost of shipping the
defective part to us. You must also bear the cost of repair to or replacement
of any part or component and the shipping charges incurred for the repair or
replacement and return to you of any part or component not covered by this
warranty, including parts or components damaged by you.
The company reserves the right to demand and receive written evidence of the
date of purchase before undertaking its obligations under this warranty. The
right to demand and receive written evidence of date of purchase extends to
all licensed dealers of Ventamatic, Ltd. products.
You should, therefore, retain your sales slip and attach a copy of it to the
warranty claim.
To start a warranty claim you must:
Contact Ventamatic, Ltd.
An RGA (Returned Goods Authorization) form is required for returns to the
factory to ensure your return can be processed efficiently and quickly. Please
contact Ventamatic, Ltd. toll-free at
800-433-1626 or via web at
www.bvc.com to obtain an RGA and follow the instructions
given.
There is no informal dispute settling mechanism available in the event of a
controversy involving this warranty.
Any and all implied warranties which may exist terminate upon the expiration
of this warranty one (1) year from the date of the original retail purchase.
Some states do not allow limitations on how long an implied warranty lasts,
so this limitation may not apply to you. Ventamatic, Ltd. is not liable to you
for incidental or consequential damages arising out of defect or malfunction
of a unit or its installation or out of any alleged breach of this warranty.
Some states do not allow the exclusion or limitation of incidental or
consequential damages, so this limitation may not apply to you.
This warranty gives you specific legal rights and you may also have other
rights which may vary from state to state.