SKY-LIGHTING DSB114WT20 Smart LED Bulb Installation Guide

SKY-LIGHTING DSB114WT20 Smart LED Bulb

FCC/ ISEDC Radiation Exposure Statement

This equipment should be installed and operated with a minimum distance of 20cm between the radiator & your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Environmental Specification:

Only install in operating environments between -20°C and +40°C (-4°F and +104°F). Federal Communication Commission Interference Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause
   undesired operation. This equipment has been tested and found to comply with the limits for a Cass B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,

ISEDC RSS Warning
This device complies with Innovation, Science and Economic Development Canada Compliance license-exempt RSS standard (s). Operation is subject to the following two conditions:

1. this device may not cause interference, and
2. this device must accept any interference, including interference that may cause undesired operation of the device.

LED LAMP

Installation Guide

DOWNLOAD AND INSTALL THE FEIT ELECTRIC APP

• Search for the Feit Electric App in the App Store or Google Play Store.
• Download and install the Feit Electric App on your smart device.
• Setup an account or log in to your existing account

INSTALL YOUR LIGHT BULB

• Install your light bulb/s) into a socket

NOTE: Constant power to the bulbs) is required at all times

ADDING YOUR SMART WI-F BULB USING THE FEIT ELECTRIC APP

• Tap+in the upper right corner, Note: if this is the first device you are setting up you can also select Add Device (A).
• Tap Lighting and select Lighting device (B).
• Power On the bulbs) and confirm the bulbs) is blinking. Then tap Confirm (C).
• You will be prompted to confirm your WiFi network and enter your password. Then tap Confirm (D).

Be sure to connect to a 2.4 GHz WIFi network that covers your installation location.

STATUS MENU
The status menu will appear. Wait until it’s completed.
NOTE: IF unsuccessful, the “Failed to Add screen will appear. Close the app and repeat the previous steps. If successful, continue to step 5.

NAMING DEVICES
To name the bulbs) tap the Pen icon, enter the new name and tap Done. The bulbs) is now ready to be controlled with the Feit Electric App.

For full user guide and setup instructions, please visit www.feit.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>