Kamstrup KWMX220 flow smart water meter device User Manual
- June 5, 2024
- Kamstrup
Table of Contents
Replace gaskets when installing new meter
Important! Be aware of maximum torque
Install meter in the correct direction of flow
Info codes and display
| Info code | Meaning |
|---|---|
| Possible leak | |
| Possible broken pipe | |
| Attempt of fraud | |
| Meter is missing water | |
| The water flows in reverse direction | |
| Flashes. The meter is still in transport mode | |
| Lights permanently. The radio is switched off | |
| Low battery |
Check the installation
The first 8 hours the meter operates in Installation Mode. The display will update every 4 seconds during Installation Mode, permitting the installer to confirm that the meter is properly operating. Every time the meter becomes dry and subsequently rewetted, Installation Mode will re-initiate
Antenna mounting
FCC Cautions
Caution: Changes or modifications not expressly approved by the party
responsible for compliance could void the users authority to operate the
equipment.
RF Exposure compliance statement: This device may be used with no
restrictions, since the source-based time-averaged output power is 60/f(GHz)
mW.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>