MIGHTY MULE MMS100 Wireless Connectivity System Installation Guide

Table of Contents

MIGHTY-MULE-MMS100
-Wireless-Connectivity-System-product

If required, punch out the access hole for the Auxiliary Antenna.
Align the connectors, then plug in the small radio module into the operator control board.
Guide the radio module antenna cable through the Auxiliary Antenna hold, then twist and tighten the antenna pointing upward.

MIGHTY-MULE-MMS100-Wireless-Connectivity-System-fig-1

Install/locate the bridge near your wireless router.
Connect the Antenna and plug in the Bridge.
Plug in the MMS100 (only one gate operator can be connected to your Bridge).
To pair/connect the MMS100 to your WiFi:
1. Download the Mighty Mule App from the Apple App Store or Google Play Store.
2. Create a Mighty Mule account, then sign in.
3. Select Add Device on the home screen.
4. Select Gate from the pop-up menu, then follow the instructions in the App (or refer to the quick start guide for your specifi model at www.mightymule.com)

MIGHTY-MULE-MMS100-Wireless-Connectivity-System-fig-3

Establishing Communication Between the Bridge and your Mighty Mule Gate Operator

Communication between the Control Board (with radio module) and Bridge Module will automatically attempt to connect.
The LED should be flashing blue as it attempts to connect to the Gate Operator.
Wait approximately 5 minutes to see if your system will connect within the “Low” power level setting.
If the light does not turn green, the power level setting will need to be adjusted.

To Adjust the Power Level Settings:

Stand next to the gate operator control box.
Open the control box and adjust the power level.
- Holddown $3 for 10Sec.A visual indication of the current power level setting will be given via the number of lit LEDs (1 for Low, 2 for Medium and 3 for High).
- Adjust the power level upto Mediumby pressing the $2 button.
- $2 increases the power level setting.
- S4 decreases the power level setting.
Adjust the power level for the Bridge using the Mighty Mule App.
- Goto the app Device Details page.
- Click on the Power Level button (should currently be indicating Low).
- Select Medium(which needs to align with the setting of that asset on the control board).
Stand next to your Bridge Module, then wait 5 minutes to ensure that the LED on the Bridge Module turns solid green.
IftheLED on the Bridge Module does not turn green after 5 minutes, repeat steps 1-4 in order to change the power level to High.

MIGHTY-MULE-MMS100-Wireless-
Connectivity-System-fig-6

We, Nortek Security & Control, LLC of 5919 Sea Otter Place, Carlsbad, CA 92010, declare under our sole responsibility that the device, MMS100 complies with Part 15 of the FCC rules. This device complies with Part 15 of the FCC Rules and Industry Canada license-exempt standard(s). Operation is subject to the following two conditions:
This device may not cause harmful interference, and This device must accept any interference received, including interference, received that may cause undesired operation.
This radio transmitter, 21449-MMS100 has been approved by Innovation, Science, and Economic Development Canada to operate with the antenna types listed below, with the maximum permissible gain indicated. Antenna types not included in this list that have a gain greater than the maximum gain indicated for any type listed are strictly prohibited from use with this device.