MIGHTY MULE MMTGB Tube Gate Bracket Instruction Manual
- June 4, 2024
- Mighty Mule
Table of Contents
MMTGB Tube Gate Bracket
Instruction Manual
BOX CONTENTS
(2) Tube Gate Brackets| (2) 3/8-16 x 1” Hex Bolts| (2) 3/8-16 x 2.5” Hex
Bolts| (4) 3/8-16 Hex Nuts| (2) 375 X .079 Washers
---|---|---|---|---
| | | | 
INSTALLING THE MMTGB BRACKET TO THE GATE CONTROLLER AND GATE
Follow the steps below to attach the MMTGB bracket to the cylindrical gate:
- Using the 3/4” length bolt and a nut, connect the existing gate arm bracket to the MMTGB bracket. Do not tighten completely.
- Position the gate arm to slide the MMTGB bracket over the desired section of the gate.
- Insert the 2 1/2” bolt through the eyes of the MMTGB bracket, then attach the nut. Do not tighten completely.
Finishing Up: With the gate closed and settled in place, tighten the 2 1/2” bolt and nut then tighten the remaining 3/4” bolt and nut. Test the gate opener, and adjust as necessary.
Mighty Mule Sales:800-543-4283 |
Mighty Mule Technical Service
800-543-1236
For more information on Mighty Mule’s full line of Automatic Gate Operators,
Gate Openers and Access Controls visit
www.mightymule.com
©2021 Nortek Security & Control LLC. All rights reserved.
Mighty Mule is a registered trademark of Nortek Security & Control LLC.
10031653 Rev-A
Documents / Resources
|
MIGHTY MULE MMTGB Tube Gate
Bracket
[pdf] Instruction Manual
MMTGB Tube Gate Bracket, MMTGB, Tube Gate Bracket, Gate Bracket, Bracket
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>