Guang AK132 BT SPEAKER TRAVEL User Manual
- June 5, 2024
- Guang
Table of Contents
AK132 BT SPEAKER TRAVEL
User Manual
PRODUCT SPECIFICATIONS:
- Working distance: 10M
- SNR: 2>85db
- Battery:3.7V 500mAh
- Normal volume playing time: 1H
- Speaker driver: 052 mm
- Power: 40/5W
- Unit size:72mm72mm” 119mm
- Unit weight: about 258g
- Charging:5V/500mAh
PRODUCT FEATURE:
- international advanced BT chip and circuit design techniques, support all BT devices;
- Built-in Low-freq radiators, Super dynamic low-frequency sound pressure gain, listening transparent and flexible.
- Can play music after pairing with BT device .for example mobile/ MID/ TV, the working distance is more than 10M.
- Support AUX IN audio input
- Built-in MP3 decoding, can directly play TF card, USB disk
- Build-in the FM radio module, convenient to auto scan and save radio channels.
- With Mic for hands-free phone call function.
- Support TWS.
KEY & SLOT FUNCTION:
-
DC 5V charging slot: use the standard mini USB micro charging cable for power charging./ AUX: it can play audio via a 3.5mm AUX cable to the audio device
-
TF slot: it can decode and play MP3 format audio when putting the TF card into the slot.
-
USB slot: it can decode and play MP3 format audio when putting a USB card into the slot.
-
Power switch
-
MIC
-
When playing music, press short for the last song/last FM station, and press long to turn down the volume.
-
When playing music, press short for the next song/next FM station, press long to turn up the volume.
-
when playing music(USB card/ TF card/LINE IN/ BT), press rt short to switch USB/TF/FM / Wireless.(switch to “line in” if via AUX cable to audio device). press long to open/close the LED light
-
When play music(USB card/ TF card/LINE IN/BT), press short for “play/pause”. under BT mode with mobile paired, press short to answer a cal I, press again to hand up. in FM mode, press short to search the station automatically, and press again to stop searching) Keep the TWS speaker under BT mode without pairing, press the “play/pause” key for 3 seconds on either of the speakers until hearing a hint”du du” for TWS mode, then can paire the mobile.
Note: Under FM mode, put in the AUX cable to get a better FM radio station
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment
The device has been evaluated to meet general RF exposure requirements, the device can be used in portable exposure conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>