TVCMALL HS-V83 In 1 Fast Wireless Charger User Manual

TVCMALL HS-V83 In 1 Fast Wireless Charger

Notice: To ensure charging 3 devices safely and efficiently, you must use 9V/2A adapter (Qualcomm Quick Charger 2.0 or 3.0) and quick charge cable.(if not use the appropriate adapter and quick charge cable, the charger may not charge phone, or may not charge 3 devices simultaneously, or may even damage the charger).

Product Appearance

1. Wireless charge area for Phone
2. Non-slip mat
3. LED Intelligent light
4. Wireless charge area for TWS earphone
5. Wireless Charge iWatch magnetically area
6. Type-C port
7. Non-slip mat
8. Radiating hole
9. Product tag

Product Introduction

The 3-in-1 wireless charger, a compact charging house, powered from only one outlet, can charge 3 devices simultaneously. When charge your mobile phone, apple watches, and your AirPods 2 or AirPods Pro or some other TWS, just put them on, wireless charging will automatically start, all this will make your desk clean and tidy, and make your life easier. The charger is so space-saving designed can help you integrate your mobile phone intellige Besides, it is fashion that the light ring is so shining showing the charging state.
and life very well, especially for Apple user.

Operation Steps

1. Connect the charger to a 9V/2A Qc3.0 adapter through a type-C quick charge cable to switch on the power;
2. Put your phone on then charge;
3. Put the apple watch on and suck it up to charge;
4. Put your earphone case on and charge.

Charging Schematic Diagram

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. During the operation of device a distance of 15cm surrounding the device and 20 cm above the top surface of the device must be respected.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>