REAL SPIRIT H2O Machine Atmospheric Water Generator User Guide
- June 5, 2024
- REAL SPIRIT
Table of Contents
REAL SPIRIT H2O Machine Atmospheric Water Generator User Guide
This quick start guide will ensure proper installation.
Please be sure to read it over and if you have questions please contact us at:
888-601-5886
Congratulations on receiving your H2O Machine
You should have two boxes in undamaged condition, should you see any damage
please be sure to take photos and contact us. Do not attempt to setup the H2O
Machine.
Step 1.
Unpack your atmospheric water generator (AWG) and carefully remove all the tape and cardboard used in shipping.
Inside the dispenser (water storage tank) box you will find tubing, an Interface Cable, and water drip tray.
Note: Find a flat, leveled location out of direct elements, like sun and rain. Winterize the unit below 40 degrees.
Step 2.
Twist the chrome water outlet into the open position (counter clockwise), and leave open. We will close it in a later step.
Step 3.
Next inside of the top box turn the pressurized tank into the open position, the tab will be parallel to the white hose.
Step 4.
Remove the blue clip with a flat head screwdriver and remove the white stopper from the IN (LEFT) with the Stopper Removal Tool.
Stopper Removal Video
Visit: https://bit.ly/3lDyaty
Or Scan QR Code with your Smart Phone Camera
Note: The Hoses and Plugs are a compression collet. You will need to push the collet IN to remove the plugs and/or hoses.
Step 5.
Take the small white plastic tubing and connect the top (IN) and the bottom box. Push the plastic tubing in about a 1/4 of an inch. Replace the blue clip to secure the tubing in place.
Next connect the interface cable to the Storage Tank and Water Generator unit.
Note: Make sure the tubing and interface cable are secured in place.
Step 6.
Close the chrome water outlet on the front.
Step 7.
Plug the Water Generator directly into an appropriate outlet. DO NOT use surge protectors
Step 8.
Turn on the Water Generator by pressing the ON/OFF into the ON position.
NOTES
- When turned on the compressor will activate in a few minutes, if your humidity is above 30-40% you will start creating water. You should see water production within 48-72 hours. Do not turn off or unplug the unit during this time.
- For new filters or initial setup, when water first flows it flushes out some of the carbon which turns the water gray. Let the water run until clear, and only consume the gray water in survival situations. It is not harmful.
- The H2O Machine will turn off around 30-40% humidity.
- Red light indicator means the storage tank is full.
- Green light indicator means the H2O Machine is working.
- Sometimes the indicators need time to calibrate, and may not display correctly at first.
- The filters should be changed every 12-18 months, including the initial black storage tank, and mesh air filter.
- To see an installation video or to winterize the unit, see YouTube.
Scheduled Maintenance
QUESTIONS?
CALL: 1-888-601-5886
For Installation and Support Videos:
Scan the QR Code with your Smart Phone Camera or Visit:
https://bit.ly/3yQlKX5
For Warranty Information Please Visit: www.H2OMachine.com
Produced and distributed exclusively by:
H2O Machine is a division of Real Spirit USA, Inc.
320 South Rock Blvd Suite 210 • Reno NV 89502 • Ph 888.601.5886
www.H2OMachine.com •
[email protected]
Read More About This Manual & Download PDF: