Shenzhen Huier Industrial H31 3-In-1 Magnetic Wireless Charger Instruction Manual
- June 5, 2024
- Shenzhen Huier Industrial
Table of Contents
Shenzhen Huier Industrial H31 3-In-1 Magnetic Wireless
Charger
Product introduction
Product Brief
- This three-in-one wireless charger can wirelessly charge three devices at the same time: cell phones, watches and headphones.
- as long as the corresponding charging area on the city, you can automatically wirelessly charge the device, so that your desktop is more neat and convenient to charge.
- the product is fixed by magnetic suction force cell phones, watches automatically calibrate the charging position, headphones designated charging area, charging stable and fast.
Appearance introduction
Product parameters
Basic parameters
- name: 3 in 1 Magnetic wireless charger
- Size: 11082118mm
- texture of material: ABS+Acrylic
- Input: DC5V/3A 9V/3A
- Output (mobile phone): 5W/7.5W/10W/15W(Max)
- Output (headset): 5W(Max)
- Output (Watch): 2.5W(Max)
- Transmission distance: ≤6mm
- work efficiency: 115-205KHz
Functions and instructions
Use steps
- Please connect this wireless charger to 5V3A,9V/3Aadapter through Type-c fast charging cable and connect the source
- Put the phone into the phone charging area cell phone magnetic suction can be charged
- Put the watch into the watch charging area to charge the watch
- Place the wireless charging Bluetooth headset case in the headset charging area to charge the headset
matters needing attention
Applicable equipment
Please check whether the phone supports magnetic wireless charging, otherwise
it may cause the phone to slip off. This product supports the fast wireless
charging function, in line with the QI wireless charging standard;
Adapter selection
The wireless charger supports 5W load when using 5V/2A output adapter. The
wireless charger supports 15W load when using QC3.0 compliant adapter; To
ensure the normal use of the charger, it is recommended to use PD fast
charging or QC3.0 compliant adapters
Other matters
Please do not put metal debris or magnetic cards on the charging board, which
may cause the charger to heat up. Slight heating is a normal phenomenon, the
phone battery charging process will be hot. Do not put the charger near fire
or corrosive environment
Lighting mode
FCC
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment
Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator and your body.