Raspberry Pi Pico W Board User Guide

: June 5, 2024
: Raspberry Pi

Table of Contents

Raspberry Pi Pico W Board
INTRODUCTION
FCC Rules
Documents / Resources

Raspberry Pi Pico W Board

INTRODUCTION

Warnings

Any external power supply used with the Raspberry Pi shall comply with relevant regulations and standards applicable in the country of intended use. The power supply should provide 5V DC and a minimum rated current of 1A. Instructions for safe use
This product should not be overclocked.
Do not expose this product to water or moisture, and do not place it on a conductive surface whilst in operation.
Do not expose this product to heat from any source; it is designed for reliable operation at normal room temperatures.
Do not expose board to high intensity light sources (e.g. xenon flash or laser)
Operate this product in a well-ventilated environment, and do not cover it during use.
Place this product on a stable, flat, non-conductive surface while in use, and do not let it contact conductive items.
Take care while handling this product to avoid mechanical or electrical damage to the printed circuit board and connectors.
Avoid handling this product while it is powered. Only handle by the edges to minimize the risk of electrostatic discharge damage.
Any peripheral or equipment used with the Raspberry Pi should comply with relevant standards for the country of use and be marked accordingly to ensure that safety and performance requirements are met. Such equipment includes, but is not limited to, keyboards, monitors, and mice. For all compliance certificates and numbers, please visit www.raspberrypi.com/compliance.

FCC Rules

Raspberry Pi Pico W FCC ID: 2ABCB-PICOW This device complies with Part 15 of FCC Rules, Operation is Subject to following two conditions:(1) This device may not cause harmful interference, and (2) This device must accept any interference received including interference that cause undesired operation. Caution: Any changes or modifications to the equipment not expressly approved by the party responsible for compliance could void user s authority to operate the equipment. This equipment has been tested and found to comply within the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Re-orient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a different circuit from that to which the receiver is connected
Consult the dealer or an experienced radio/TV technician for help.

Designed and distributed by

Raspberry Pi Ltd
Maurice Wilkes Building
Cowley Road
Cambridge
CB4 0DS
UK
www.raspberrypi.com
Raspberry Pi Regulatory compliance and safety information
Product name: Raspberry Pi Pico W
IMPORTANT: PLEASE RETAIN THIS INFORMATION FOR FUTURE REFERENCE.