Tamiya TAM58518A SUPER CLOD BUSTER User Manual

Tamiya TAM58518A SUPER CLOD BUSTER

ITEMS REQUIRED

Wheel type transmitter is also available.

Tamiya 7.2V battery

Compalible charger

TAMIYA PAINT COLORS

Twin motor

 TOOLS REQUIRED

CAUTION

A supervising adult should also read the instructions if a child assembles the model when assembling this kit, tools including knives are used. Extra care should be taken to avoid personal injury. Keep out of reach of small children. Children must not be allowed to put any parts in their mouths or pull vinyl bags over their heads.

PRECAUTIONS

CHANNEL R/C SYSTEM

COMPOSITION OF 2 CHANNEL RIC UNIT

• Transmiiter: Serves as control box. Steering wheel/stick and throttle trigger/stick movements are transformed into radio signals which are transmined through the antenna.
• Trim: Lever for adjusting central posi11on of servo wheel & Trigger: Moves servos, which steer car and adjust throttle.
• Receiver. Accepts signals from the transmitter and converts them into pulses that operate the model’s servo and speed controller.
• Electronic speed controller: Accepts signals received from the receiver and controls the current going to the motor steering servo.
• Transforms signals received lrom the receiver into mechanical movements.

Checking R/C equipment

• Install batteries.
• Extend antenna. Loosen and extend.
• Connect charged battery.
• Switch on.
• Trlms In neutral.
• Steering wheel in neutral.
• Servo In neutral position.

Atteching

Attaching steering rods

Chassis assembly

Attehing from body

Attaching steering servo

Battery holder

Atteching short tube

Axle tube

Axle tube short

Atteching gear

Gearbox assembly

Pinion gear

Motor Atteching

Suspension

Fitting suspension arm

Fitting in Lateral way

Axle stays Attachment

Assembling

Assembling tie rods

Guard assembly

Attaching gearbox guard

Attaching gearboxes

Attaching dampers

Attaching R/C unit

When using a 2.4GHz receiver. position so that the antenna cable protrudes from the body.

Wheel assembly

Flt Into groove

Wheel (left)

Apply instant cement

Wheel (right)

Attaching wheels

Installing Battery pack

Painting body

Apply masking stickers in positions shown.

Paint whole body In Mica Blue. After paint has completely dried, mask over the areas to remain Mica Blue using masking stickers, masking tape (available separately) or parts bags used in kit. Paint the body with Gun Metal. Remove masking before paint has completely dried.

Oil bar assembly

Super charger

Roll bar

Atteching roll bar

Atteching wind shield

Front grille assembly

Attaching front grille

OPTIONS

Light Bulb Set

Marking

Attaching body

Avoid continuous running. Allow the motor to cool after each battery run.

PARTS

PARTSx1 9006236

PARTS X2 0005294

PARTSX1 0005971

PARTS x2 0005296

PARTS X1 o006970

Drive shaft bag

Press parts bag

 Rod bag

Metal parts small box

Dltterentlal spur gear

Large bevel gear

SOT Counter and Counter gear

Tool bag

Required tools

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>