JBC JTSE-UA Precision Heater Hose Set Instruction Manual
- June 5, 2024
- JBC
Table of Contents
JBC JTSE-UA Precision Heater Hose Set
This manual corresponds to the following reference: TE-TB
Packing List
The following items are included:
-
TE Handle … 1 unit Ref. TE-B
-
Heating Element for TET ……… 1 unit Ref. 0012374 (for 100V/120V/230V)
-
Manual ……… 1 unit Ref. 0029031
Changing TET Heater Hose Set
Only perform this operation when the station is turned off. Use a spanner to unscrew the nut (1) and remove the tool hose (2). Insert the new hose, make sure it is pushed all the way into the connector (2), and tighten the nut (1).
Features
TET Precision Heater Hose Set allows to repair small and medium SMDs . It works with JTU Control Unit and TE Nozzles.
Replacing the Heating Element
Note: Only perform this operation when the heating element is cold and the unit is disconnected from the mains.
- Loosen the screw (1) and pull the worn heating element out of the handle (2).
- Insert the new heating element, make sure its pushed all the way in (2) and tighten the screw (1).
Specifications
TET Precision Heater Hose Set
Ref.: TE-TB
- Hose Length: 1100 mm / 43.31 in
- Total Net Weight: 187.2 g / 0.413 lb
- Package Dimensions/Weight: 300 x 125 x 65 mm / 267.7 g (L x W x H) 11.81 x 4.92 x 2.56 in / 0.590 lb
Complies with CE standards. ESD safe.
Warranty
JBC’s 2 year warranty covers this equipment against all manufacturing defects, including the replacement of defective parts and labour. Warranty does not cover product wear or misuse. In order for the warranty to be valid, equipment must be returned, postage paid, to the dealer where it was purchased.
Disposal
This product should not be thrown in the garbage. In accordance with the European directive 2012/19/EU, electronic equipment at the end of its life must be collected and returned to an authorized recycling facility.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>