FUDESY FLDP746E26 Outdoor Wall Lantern Instruction Manual
- June 4, 2024
- FUDESY
Table of Contents
FUDESY FLDP746E26 Outdoor Wall Lantern
WARM TIPS
- These instructions are for your safety. Please read through them thoroughly prior to installation and retain them for future reference.
- All fitting must be installed by a competent person in accordance with local regulations.
- Check the pack and make sure you have all the parts listed.
- Remove all packaging, and wrap from the product.
- Decide on the appropriate location for your product.
- CAUTION: IP44 is guaranteed when the product is properly installed and sealed.
- Always avoid the product being located in a corrosive environment.
- Always refer to the installation drawing for the orientation of the product.
- The product must be securely fixed to the mounting surface using the screws and wall plugs supplied.
- Take care not to drill into any pipes or mains cables beneath the surface during mounting holes preparation.
- IMPORTANT: The fixing point(s) selected must be capable of supporting the full weight of the light fitting.
- A wiring diagram is for reference only. Always refer to the terminal mark ing for wiring. Ensure that all electrical connections are tight and that no loose strands are left out of the terminal block.
- Never put anything on the product or hang anything on any part of this product.
- Never use the terminal cables to bear the product’s weight.
- When the product does not light after installation:
- Ensure there is no electricity failure
- Ensure all the connections are secured
- If you have any doubt about the installation/ use of this product, consult a qualified electrician.
- Always disconnect the product from the mains for at least 10 minutes allowing it to cool down before my maintenance or adjustment. It is recommended to have a regular schedule of care and maintenance to keep the surface condition well.
TECHNICAL DATE
| Supply Voltage: | 120V~ 60Hz |
|---|
Wattage:
| Max 40W| ****
Lamp Type:
| E26,Type A, Incandescent
Max 20W| E26,CFL Lamp
Max 15W| E26,LED Lamp
Bulb Type:| 8W 3000K 1200LM
[g]| ****
Class II product-Double Insulated-No earth required.
IP44| ****
Splash-proof
“– f
/ ,
| ****
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or local store for recycling advice.
THE PACKAGE INCLUDE
Installation
If there is a ground wire in your wire box, you need to connect the ground wire with the GND screw on the bracket
Care
Warranty Period and Conditions
3-Year Warranty: We Provide You With a 3-Year Warranty And Efficiency In Customer Support. (Please note: The bulb is a vulnerable product and is not covered by a warranty)
At FUDESY we devote special attention to selecting high-quality materials and manufacturing techniques that enable us to create designer and durable product rangers. This is why we offer a 3-year warranty against product manufacturing defects. This product is under warranty for 3 years from the date of purchase, for normal, non-professional household use. The warranty shall only apply upon presentation of the till receipt or the invoice on Amazon. The Warranty covers product breakdowns and malfunctions under the condition that the product is used in accordance with its intended use and subject to installation and maintenance in accordance with good practice and the information contained in the user’s manual. The product must be installed so that it may be later removed without damaging it. This contractual warranty does not cover defects and damage caused by the natural wear of parts, bad weather, flooding heat releases, or freezing damage caused by water quality(hardness, aggressiveness, corrosion, etc.), the presence of foreign bodies transported by water or otherwise(sand, filings, etc.) or the lack of room ventilation, and damages that could be the consequence of improper use, misuse, negligence, accident or maintenance
The following are also excluded from the warranty: harmful consequences due to the use of accessories and non-original equipment manufacturer or improper replacement parts, disassembly, or product modification.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>