alula RE106M Tilt Sensor User Manual
- June 5, 2024
- alula
Table of Contents
alula RE106M Tilt Sensor
Tilt Sensor is a full-featured security transmitter typically used to sense the tilt of overhead garage doors and windows. It will alarm when the sensor is tilted more than 45 degrees
Features
Industry-leading wireless range and battery life
Enroll by placing the panel into wireless enrollment mode and then sending an enrollment signal from the sensor
Sending an Enrollment Signal
With the battery tab removed, open the cover to trip tamper.
Install by mounting the sensor to the inside of a door or window using the mounting screwlocations. For garage door installations, the sensor should be mounted to the top panel of the overhead door. This ensures that the sensor closes only when the door is fully closed, and is best for RF range.
Pro Tips
3M™ VHB™ Tape works great for mounting if the surface is properly prepared and firm pressure is applied for over 10 seconds.
Surface Preparation
- Clean the surface
- Ensure the mounting surface temperature is above 50 °F
Specifications
Physical
Housing Dimensions Weight with Battery Mounting Fastener
Cover Securing Screw (optional, not provided)
| 3.25 x 1.40 x 1.05 inches (8.3 x 3.6 x 2.7 cm)
1.90 ounces (54 grams)
4 or #6 screws (not provided)
Pan Head, #1 x .25in, A/AB Thread Forming (sheet metal) screw, McMaster 90190A051
Environmental
Operating Temperature Maximum Humidity| 32 to 120 °F (0 to 49 °C)
85% non-condensing relative humidity
Sensor Specifications
Frequency Replacement Battery Nominal Battery Life Battery Voltage Current
Draw Transmitted Indications| 319.5 MHz
One Panasonic® CR123A 10 to 15 years
3.0 VDC (Nominal), 2.2 VDC (Low)
20 mA (Maximum), 0.6 uA (Quiescent) Cover Tamper, Low Battery, Supervision
Certification
RE106M| FCC, IC
FCC NOTICE
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference that may be received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by Alula could void the user’s authority to operate this equipment. FCC ID: U5X-RE101
IC NOTICE
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
- This device may not cause interference, and
- This device must accept any interference, including interference that may cause undesired operation of the device.
Alula is a trademark owned by Alula Holdings, LLC.
Interlogix is a trademark owned by UTC. Qolsys is a trademark owned by Qolsys,
Inc. Alula products will function with one of either Interlogix or Qolsys
systems. However, no Alula product is produced by, endorsed by, nor is
officially associated with Interlogix or Qolsys. Alula recommends verifying
proper enrollment and operation, per control panel installation instructions,
at installation. 3M and VHB are trademarks owned by 3M Company. Panasonic is a
registered trademark owned by Panasonic Corporation
- 47-00021-01
- REV A
- 2022-03-23
- Tech Support Line
- (888) 88-ALULA
- 888-882-5852 alula.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>