alula CAM-OD-JS1-AI Outdoor Bullet Camera Installation Guide
- June 5, 2024
- alula
Table of Contents
CAM-OD-JS1-AI Outdoor Bullet Camera
Installation Guide
Outdoor Bullet Camera
Save this guide for future reference CAM-OD-JS1-AI
What’s in the box
Hardware overview
Camera setup
a. Insert a MicroSD card in the slot on the back of the camera
b. Power on the camera and wait for about one minute until the LED indicator
blinks in a 3-flash repeating pattern
Note: It is best to test the camera’s functionality with the app prior to
mounting.
App configuration
a. Open the Alula Security app
b. In the app, browse to Cameras, then tap the `+’ icon on the top right of
the screen and follow your device’s on-screen prompts
Don’t have the app?
Scan the QR code for your device’s app store here
|
---|---
https://apps.apple.com/us/app/alula-security/id1356152180|
https://play.google.com/store/apps/details?id=net.alula.android&hl=en_US&gl=US
Camera installation
a. When mounted outdoors, the camera connections should be appropriately
protected from the weather. Mount the camera on a junction box or feed the
camera cable into the hole and pull it out from the interior. Use fish tape to
pull the cable through the wall if needed. Caulk the hole properly to avoid
water damage.
b. Plug camera into power supply. If connecting your camera with a wired
connection, plug the ethernet cable into your router.
TRADEMARKS
Alula is a trademark owned by Alula Holdings, LLC. Wi-Fi is a trademark of The
Wi-Fi Alliance. Android is a trademark of Google LLC. IOS is a trademark of
Cisco in the U.S. and other countries and is used under license by Apple Inc.
FCC WARNING
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference. (2) This device must accept any interference that may be
received, including interference that may cause undesired operation.
Caution: any changes or modifications to this device not explicitly
approved by the manufacturer could void the user’s authority to operate this
equipment.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance of 20cm between the radiator & your body.
****Products with CE Marking comply with the EMC Directive (2014/30/EU); Low
Voltage Directive (2014/35/EU); RED (2014/53/EU); ROHS Directive (2011/65/EU)
issued by the Commission of the European Community. Compliance with these
directives implies conformity to the following European Norms: EMC: EN 301 489
LVD: EN 62368-1 Radio: EN 300 328
If the camera system no longer functions or can no longer be repaired, it must
be disposed of according to the valid statutory regulations. Disposal of spent
batteries/accumulators: You are required by law (Battery Ordinance) to return
all spent batteries and accumulators. Disposing of spent
batteries/accumulators with common household waste is prohibited!
Batteries/accumulators that contain hazardous substances are marked with
symbols on the side. These symbols indicate that it is prohibited to dispose
of these batteries/accumulators in household waste. The abbreviations for the
respective heavy metals are Cd=cadmium, Hg=mercury, and Pb=lead. You can
return spent batteries and accumulators that can no longer be charged to the
designated collection points in your community, outlets or wherever batteries
or accumulators are sold. Following these instructions will allow you to
fulfill the legal requirements and contribute to the protection of our
environment!
Canada Statement
This device contains license-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science, and Economic Development Canada’s license-exempt
RSS(s). Operation is subject to the following two conditions: (1) This device
may not cause interference. (2) This device must accept any interference,
including interference that may cause undesired operation of the device.
The device meets the exemption from the routine evaluation limits in section
2.5 of RSS 102 and compliance with RSS-102 RF exposure, users can obtain
Canadian information on RF exposure and compliance.
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter. This equipment should be installed and operated
with a minimum distance of 20 centimeters between the radiator and your body.
This radio transmitter [enter the device’s ISED certification number] has been
approved by Innovation, Science, and Economic Development Canada to operate
with the antenna types listed below, with the maximum permissible gain
indicated. Antenna types not included in this list that have a gain greater
than the maximum gain indicated for any type listed are strictly prohibited
from use with this device.
The antenna (type / gain / impedance) which can be used with the transmitter
is: External antenna/2dBi/50
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>