JBC 0012374 Heating Element for TET Instruction Manual
- June 5, 2024
- JBC
Table of Contents
JBC 0012374 Heating Element for TET
Packing List
The following items are included
Changing TET Heater Hose Set
Only perform this operation when the station is turned off. Use a spanner to
unscrew the nut (1) and remove the tool hose (2). Insert the new hose, make
sure it is pushed all the way into the connector (2), and tighten the nut
(1).
Features
TEH Heating Element is designed to be used with TE Handle. Both, as a set, work with JTU Control Unit and TE Nozzles.
Replacing the Heating Element
Note: Only perform this operation when the heating element is cold and
the unit is disconnected from the mains.
Loosen the screw (1) and pull the worn heating element out of the handle (2).
Insert the new heating element, make sure its pushed all the way in (2) and
tighten the screw (1).
Specifications
TEH Heating Element for TET
Ref.: 0012374
- Total Net Weight: 28 g / 0.062 lb
- Package Dimensions/Weight: 236 x 41 x 41 mm / 40 g
(L x W x H) 9.29 x 1.61 x 1.61 in / 0.088 lb
Complies with CE standards.
ESD safe.
Warranty
JBC’s 2 year warranty covers this equipment against all manufacturing defects,
including the replacement of defective parts and labour. Warranty does not
cover product wear or misuse. In order for the warranty to be valid, equipment
must be returned, postage paid, to the dealer where it was purchased. This
product should not be thrown in the garbage. In accordance with the European
directive 2012/19/EU, electronic equipment at the end of its life must be
collected and returned to an authorized recycling facility.
www.jbctools.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>