JAMARA 172131 Pro Decal Heat Sealing Iron Instructions

: June 5, 2024
: JAMARA

Table of Contents

JAMARA 172131 Pro Decal Heat Sealing Iron
General information
Box contents
Using the Iron
Temperature Settings
Safety and operating instructions
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

JAMARA 172131 Pro Decal Heat Sealing Iron

JAMARA-172131-Pro-Decal-Heat-Sealing-Iron-product

General information

Jamara e.K. is not liable for any damage caused to the product itself or by it, if this is due to improper operation or handling errors. The customer alone bears the full responsibility for the proper use and handling, including in particular, assembling, charging and using the model, and selecting the area in which to use it. Please refer to the operating and user instructions, which contain important information and warnings.

Certificate of Conformity
Hereby JAMARA e.K. declares that the product „Heat sealing iron Pro Decal, No. 172131“ complies with Directive 2014/30/EU, 2014/35/EU and 2011/65/EU. The full text of the EU Declaration of Conformity is available at the following Internet address: www.jamara-shop.com/Conformity

Read the complete instructions and security instructions carefully before using the model.

Caution! Please fully and carefully read warnings/ safety instructions. These are for our own security and can avoid accidents/injuries.

Box contents

Heat sealing iron
2 exchangeable soleplates (round/flat)
Stand
Instructions

Using the Iron

Set the required temperature with the thermostat (HI / LOW) and connect the plug of the iron to a wall socket.

HI = 270° to 318° C (518° to 604,4° F)
LOW = 186° to 215° C (366,8° to 419° F)

Measure the temperature with a thermometer

Temperature Settings

Please refer to the temperature recommended by the foil manufacturer. If the manufacturer have included no recommendations for the use of the foil, you can refer to the following guidelines.

At approx. 100°C the bonding part of the foil will start to glue tot he model.
At approx. 130°C the foil will stick to the model
At approx. 150°C the foil can shrink
At approx. 250°C the foil will start to melt and will be unusable

Attention! We can not guarantee success with the above mentioned temperatures.

Safety and operating instructions

Never leave the sealing iron unattended during operation.
Always place the iron on the supplied stand during operation. Through the temperature your furniture might otherwise be damaged.
Make absolutely sure no combustible materials (eg, paper, etc.) is placed near the iron. Risk of fire!
Make sure that no children or pets are near the heated iron. Risk of injury!
NEVER use the iron for ironing clothes. The high temperatures is not suitable and would damage
your clothes.
Avoid any contact with the ironing surface of the iron.
Do not use in case the iron is dropped or it is obviously damaged.
Always disconnect the iron from the mains when not in use.
This product is not intended for use by individuals (including children) with reduced physical,
sensory or mental capabilities or lack of experience and / or knowledge, unless they are supervised by a person responsible for their safety and have been given instructions about how the product should be used.
Must always be kept away from children

Disposal restrictions
Electrical appliances must not be disposed of in domestic waste and must be disposed of separately. You are obliged to take out the batteries, if possible, and to dispose of the electrical equipment at the communal collection points. Should personal data be stored on the electrical appliance you must remove them by yourself.

JAMARA e.K.
Manuel Natterer Am Lauerbühl 5 DE-88317 Aichstetten