beko HNU71311S Integrated Filter Cooker Hood User Manual

: June 5, 2024
: Beko

beko HNU71311S Integrated Filter Cooker Hood User Manual

Please read this user manual first!

Dear Valued Customer,
Thank you for preferring this Beko appliance. We hope that you get the best results from your appliance which has been manufactured with high quality and state-of-the-art technology. For this reason, please read this entire user manual and all other accompanying documents carefully before using the appliance and keep it as a reference for future use. If you hand over the appliance to someone else, give the user manual as well. Follow the instructions by paying attention to all the information and warnings in the user manual.
Remember that this user manual may also apply to other models. Differences between models are explicitly described in the manual.

Meanings of the Symbols
Following symbols are used in various sections of this user manual:

| Important information and useful hints about usage.
---|---
| WARNING: Warnings against dangerous situations concerning the security of life and property.
**| WARNING: Warning for danger of fire.
| WARNING:** Warning for electric shock.

This appliance has been produced in environmentally friendly facilities without harming the nature.

Important safety and environmental instructions

1.1 General Safety

Important Safety Instructions Read Carefully And Keep For Future Reference This section contains safety instructions that will help protect from the risk of fire, electric shock, exposure to leak microwave energy, personal injury, or property damage. Failure to follow these instructions shall void any warranty.

Beko products comply with the applicable safety standards; therefore, in case of any damage to the appliance or power cable, it should be repaired or replaced by the dealer, service center, or a specialist and authorized service alike to avoid any danger. Faulty or unqualified repair work may be dangerous and cause risk to the user.
This appliance is intended to be used in household and similar applications such as:
– Staff kitchen areas in shops, offices, and other working environments;
– Farmhouses
– By clients in hotels, and other residential type environments;
– Bed and breakfast type environments.
Operate the appliance for its intended purpose only as described in this manual.
The manufacturer cannot be held liable for damages resulting from improper installation or misuse of the product.
This appliance can be used by children aged 8 years and above and persons with reduced physical, sensory, or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved.
Children shall not be allowed play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
The minimum distance between the supporting surface for the cooking vessels on the hob and the lowest part of your product must be at least 65 cm.
If the instructions for installation of the gas hob specify a greater distance, this has to be taken into account.
Make sure that your main power supply complies with the information supplied on the rating plate of the appliance.
Never use the appliance if the power cable or the appliance itself is damaged.
Prevent damage to the power cable by not squeezing, bending, or rubbing it on sharp edges. Keep the power cable away from hot surfaces and naked flame.
Use the appliance with a grounded outlet only.
WARNING: Do not connect the appliance to the mains until the installation is fully complete.
Place the appliance in a way so that the plug is always accessible.
Do not touch the lamps if they have operated for a long time. They can burn your hands since they will be hot.
Follow the regulations set out by competent authorities on the discharge of the exhaust air (this warning is not applicable for use without flue).
Operate your appliance after putting a pot, pan etc. on the hob. Otherwise, high heat may cause deformation in some parts of your product.
Turn off the hob before taking the pot, pan, etc. from it.
Do not leave hot oil on the hob. Pans with hot oil may cause self-combustion.
Pay attention to your curtains and covers since oil may catch fire while cooking food such as fries.
Grease filter must be cleaned at least monthly. Carbon filter must be replaced at least every 3 months.
Product shall be cleaned ac- accordance with the user manual. If the cleaning was not carried out in accordance with a user manual, there may be a fire risk.
Do not use non-fire-resistant filtering materials instead of the current filter.
Only use the original parts or parts recommended by the manufacturer.
Do not operate the product without the filter and do not remove the filters while the product is running.
In the event of being started any flame, de-energize your product and cooking appliances.
In the event of be started any flame, cover the flame and never use water to extinguish it.
Unplug the appliance beforeeach cleaning and when the appliance is not in use.
The negative pressure in the environment should not exceed 4 Pa (4×10 bar) while the hood for the electric hob and appliances running on another type of energy but electricity operate simultaneously.
In the environment where the appliance is being used, the exhaust of devices running on fuel oil or gas, such as room heaters must be absolutely isolated or the device must be hermetical type.
When connecting the flue, use pipes with a diameter of 120 or 150 mm. Pipe connection must be as short as possible and have as few elbows as possible.
Danger of choking! Keep all the packaging materials away from children. CAUTION: Accessible parts may become hot when used with cooking appliances.
The product outlet must not be connected to air channels that include other smoke.
The ventilation in the room may be insufficient when the hood for the electric hob is used simultaneously with the devices operating on gas or other fuels (this may not apply to appliances that only discharge the air back into the room).
Objects placed on the product may fall. Do not place any objects on the product.
Do not flambe under your product.
WARNING: Before installing the Hood, remove the protective films.
Never leave high naked flames under the hood when it is in operation
Deep fat fryers must be continuously monitored during use: overheated oil can burst into flames.

1.2 Compliance with the WEEE Directive and Disposing of the Waste Product:
This product complies with EU WEEE Directive (2012/19/EU). This product bears a classification as the symbol for waste electrical and electronic equipment (WEEE).

This symbol indicates that this product shall not be disposed of with other household wastes at the end of its service life. Used devices must be returned to an official collection point for the recycling of electrical and electronic devices. To find these collection systems please contact your local authorities or the retailer where the product was purchased. Each household performs an important role in recovering and recycling old appliances. Appropriate disposal of used appliances helps prevent potential negative consequences for the environment and human health.

1.3 Compliance with RoHS
Directive
The product you have purchased complies with EU RoHS Directive (2011/65/EU). It does not contain harmful and prohibited materials specified in the Directive.

1.4 Package Information
Packaging materials of the product are manufactured from recyclable materials in accordance with our National Environment Regulations. Do not dispose of the packaging materials together with the domestic or other wastes. Take them to the packaging material collection points designated by the local authorities.

General appearance

2.1 Overview

Control and parts

Air exhaust flue
Body
Hob lighting
Control panel
Grease filter

Technical data

Model	HNU51311SH	HNU51311S
Supply voltage & frequency	220-240V∼50 Hz
Lamp power	2×3 W
Motor power	185 W
Flow rate – 3. Level	381 m3/h
Insulation class	F

Using the appliance

3.1 Use of the appliance

Bring the lamp switch to position ‘0’ to turn off the lamp.
Bring the lamp switch to position ‘1’ to turn on the lamp.
Bring the motor switch to position ‘0’ to turn off the motor.
You can operate the motor in the 1st speed level minimum and in the 3rd speed level maximum according to the density of cooking steam.

3.2 Energy efficient usage

When using your appliance, adjust the speed settings according to vapor and odor intensity, in order to save energy.
Use low speeds (1-2) under normal conditions, and high speed (3) for intense odor and vapor.
The lamps on the hood are placed for illuminating the cooking area.
Using them for environmental lighting shall cause unnecessary energy expenditure and insufficient lighting.

3.3 Operating the hood

Your appliance contains a motor that has various speeds.
For better performance, we recommend using low speeds under normal conditions and high speeds in cases of strong odors and intense vapor.
You can start your appliance by pressing the desired speed setting button. (A, B, C).
You may illuminate the cooking area by pressing the lamp (D).

3.4 Lamp replacement

mp|
---|---
Power| 3 W
Socket| E14
Voltage| 220 — 240 W
Dimension| 35×100 mm
ILCOS Code| DRBB/F-3-220-240-E14-35/100
Luminous flux| 410 Im
Correlated color temperature| 2700 K

This product contains a light source of energy efficiency class “E”.

Remove the aluminum cartridge filter. Remove the faulty lamp and replace it with the one having the same value.

WARNING: Cut the power supply of the hood. Lamps may burn your hands while hot, so wait for them to cool down.

Using the appliance

If the appliance breaks down or gets damaged, shut down the fuse or unplug the appliance and call the authorized service agent.
If the supply cable is damaged, it must be replaced by the manufacturer, its service agent, or similarly qualified personnel to avoid any danger.
Shut down the fuse or unplug the appliance in case of a breakdown of the lamps of the appliance. Replace immediately the faulty lamps in order to prevent other lamps from being overloaded (wait for the lamps to cool down first).
Replace aluminum grease filter.

3.5 Operation with chimney connection

Vapour is extracted through the flue duct, which is fastened to the connection head on the hood.
The diameter of the flue duct must be the same as the connection ring. In horizontal settings, the pipe has to have a slight upward slope (around 10º) so that the air can exit the room easily.

3.6 Operation without chimney connection

• Air is filtered through the carbon filter and recirculated in the room. Carbon filter is used when it is impossible to use a flue in the house.
• In flueless use, remove the flaps inside the flue adapter.
• Remove the aluminum grease filter. To install the carbon filter, fit the filter to the tabs by centering it on the plastic piece on both sides of the fan body. tighten it by turning right or left.

Cleaning and maintenance

Before cleaning and maintenance, unplug the product or turn off the switch.

4.1 Cleaning of the grease filter
This filter retains the oil particles in the air. Grease the filter may change color as they are washed; this is normal and does not require replacing your grease filter.

Push the grease filter lock forward.
Then pull it slightly down and pull it out. Otherwise, you can bend the filter. Wash and rinse Grease filter with liquid detergent and replace grease filter to its sockets by carrying out the steps specified above in reverse order. This filter retains the oil particles in the air.

You may wash your grease filter in the dishwasher.
CAUTION: In case of normal use, clean your filter once in a month.

4.2 Replacement of Carbon Filters

Odour removing filters contain charcoal (Active carbon). Grease filter must be installed in the product, regardless of whether or not carbon filters are used.

Remove the grease filter.
To remove the carbon filter, remove the carbon filter from its housing by rotating it counter-clockwise from the tab.
Install the new carbon filter.
Install the grease filter.

CAUTION

Carbon filter shall never be washed.
Replace carbon filters once every 3 months.
You can obtain the carbon filter from the authorized services.

Setting up the device

WARNING: Before starting the installation, read the safety information on user manual.
WARNING: Failure to install with screws and stabilizers in accordance with these instructions may result in electric shock.

For the installation of the hood, please contact the nearest Authorized Service.
It is the customer’s responsibility to prepare the location and electrical installation of the hood.

5.1 Position of the appliance

Distance between the cooker and the cooker hood must be considered prior to assembly. This distance should be 65 cm.
Distance must be measured from the surface of the grate for gas cookers,
from surface of glass for electric cookers.

5.2 Package content

Hood
Ø120 mm plastic flue
User manual
Installation draft
4×3,9×32 screw ( Used for installation of hood )
3.5×9.5 screw (Used for installation of a plastic flue)

The information required to make the location suitable for the installation of the hood is given below.

5.3 Installation of the appliance

Use protective gloves and glasses while performing drilling and cutting operations.

Setting up the device

Figure 1

5.4 Drilling mounting holes

Adhere to the installation template provided with the appliance onto the surface on which the installation will be carried out.
Drill the holes indicated on the installation draft with A, B, C, D using a Ø4 mm drill bit. (Figure 1)

Figure 2

Cut the lower surface of the cabinet where the hood will be installed in the dimensions specified in the technical drawing (Figure 2).

Figure 3

3.5×9.5 screw
Ø 120 mm plastic flue
BodyValve pin socket
• Attach the plastic flue contained in the package to the body of the appliance using 2 screws 3.5×9.5. Do not rub it against the surface. (Figure

Figure 4

Air discharge pipe
Air exhaust flue of the hood
• Attach the air discharge pipe to the air exhaust flue and fasten via clamp (Figure 4).

Setting up the device

CAUTION: As the bends and elbows in the aluminum pipe will cause a decrease in the air suction power, using these must be avoided as much as possible.

Figure 5

Kitchen cabinet bottom view
4×3,9×32 hood installation screw
• Place the hood into the kitchen cabinet and attach the hood to 4 installation holes drilled before (Figure 5).

5.5 Storage

If you do not intend to use the appliance for a long time, please store it carefully.
Please make sure that the appliance is unplugged, cooled down, and totally dry.
Store the appliance in a cool and dry place.
Keep the appliance out of the reach of children

5.6 Handling and transportation

During handling and transportation, carry the appliance in its original packaging. The packaging of the appliance protects it against physical damages.
Do not place heavy loads on the appliance or the packaging. The appliance may be damaged.
Dropping the appliance will render it non-operational or cause permanent damage.

Troubleshooting

Troubleshooting	Reason	Help
The product does not work.	Check your fuse.	Your fuse might be closed, make

it work.
The product does not work.| Check the electrical connection.| The mains voltage should be between 220-240 V.
The product does not work.| Check the electrical connection.| Check if the other products in your kitchen are working or not.
The lighting lamp does not work.| Check the electrical connection.| The mains voltage should be between 220-240 V.
The lighting lamp does not work.| Check the lamp switch.| The lamp switch should be in the “on” position.
The lighting lamp does not work.| Check the lamps.| The lamps of the product should not be faulty.
The air intake of the product is poor.| Check the aluminum filter.| The aluminum oil filter should be cleaned at least once a month under normal conditions.
The air intake of the product is poor.| Check the air vent flue.| The air vent flue should be in the “on” position.
The air intake of the product is poor.| Check the carbon filter.| For products with carbon filters, the filter should normally be changed every 3 months.

Cooker Hood / User Manual
Arçelik A.Ş.
Karaağaç Caddesi No: 2-6, 34445,
Sütlüce, İstanbul, Türkiye
www.beko.com